Fill Dirt in Reddick, FL

Costs vary by supplier, delivery distance, and volume. A tri-axle dump in the Reddick area typically carries about 12 to 16 cubic yards of fill dirt; at current local rates expect roughly $10 to $30 per cubic yard, so a truckload can run about $120 to $480 as a rough range. Hello Gravel requires a minimum order (check your zip code) and can provide an exact, upfront quote and delivery window.

Yes, fill dirt is usually cheaper than gravel because it is unprocessed soil with little to no rock or crushed stone. Gravel costs more due to quarrying, crushing, and screening, and is chosen for drainage and structural base layers rather than bulk fill.

Fill dirt is mostly soil with minimal organic material used to raise or level ground; it is not intended as a finished surface. Gravel is crushed rock used for drainage, driveways, and structural bases. Use fill dirt to change grade and gravel to create stable, draining surfaces.

In Florida, including Reddick, fill dirt commonly reflects local geology so it can be sandier or include local clay and shell fragments. It is sold to build up low spots, backfill foundations, and change grades; it generally contains little organic matter, so it is not ideal for planting without added topsoil.

Volume depends on width and depth. For a typical 100 ft by 10 ft driveway with a 4-inch base you need about 12.3 cubic yards (100 x 10 x 4/12 ÷ 27). Increase the depth to 6 inches and you need about 18.5 cubic yards; get a quote from Hello Gravel to include compaction allowance.

One cubic yard is a 3 ft x 3 ft x 3 ft cube. Visually it is roughly the size of a large washing machine stacked three high; many pickup beds hold about half to one cubic yard depending on truck size and how the material is loaded.

Volume depends on depth. For 1,000 sq ft: 2 inches = about 6.2 cubic yards, 4 inches = about 12.3 cubic yards, 6 inches = about 18.5 cubic yards. Multiply by your local per-yard price to estimate cost, and add 5-10% for compaction and settling.

Yes, fill dirt is commonly used to raise or level yards, but it must be placed in thin lifts and compacted to avoid future settling. If you plan to grow grass or plants, finish with several inches of topsoil or amended soil because fill dirt lacks nutrients and organic matter.

If you need to raise or infill under the slab by 6 inches across a 20 x 20 area, you would need about 7.4 cubic yards of material (20 x 20 x 6/12 ÷ 27). Note that most slabs require a compacted gravel base rather than loose fill dirt, so confirm slab subgrade specs with your contractor before ordering.

You can put gravel over fill dirt, but only after the fill dirt has been properly placed and compacted. Loose or uncompacted fill will settle and cause the gravel surface to rut; in many cases a geotextile and compacted crushed stone base are recommended for long-term stability.

Yes — compaction is important anywhere, including Reddick, because uncompacted fill will settle and shift over time. Place fill dirt in 4- to 6-inch lifts and compact each lift with a plate compactor or roller; heavier equipment is used for larger projects.

Not well on bare fill dirt because it usually lacks organic matter and nutrients needed for turf. For a healthy lawn in Reddick, add 3 to 6 inches of topsoil or a soil/compost mix over the fill, then seed or sod. Proper grade, drainage, and soil preparation are also important in Florida's climate.

Prices change by supplier and delivery, but a typical local range is about $10 to $30 per cubic yard for basic fill dirt. For an accurate price for your address and desired delivery date, request a quote through Hello Gravel to see any delivery fees and minimums.

The 70/30 rule commonly refers to mixing about 70% topsoil with 30% organic amendment (compost) for planting beds. When using fill dirt to raise grades, follow the rule by covering the compacted fill with a suitable topsoil/compost blend (about 3 to 6 inches) before planting to ensure nutrient retention and good plant growth.

Have the truck dump as close to the work area as possible, then spread the material in 3- to 6-inch layers with a shovel, rake, or skid-steer. Compact each layer, check elevations with a level or string line, and finish with topsoil where you will plant. You can request tailgate spreading at checkout, but drivers only perform it at their discretion.