Fill Dirt in Fort McCoy, FL

Delivered fill dirt in the Fort McCoy area commonly ranges from about $12 to $30 per cubic yard, or roughly $15 to $40 per ton, depending on source, distance, and moisture content. Prices vary with supply, haul distance from local pits in Marion County, and whether material is screened or mixed with sand or clay; use our checkout to get an exact, up-to-date quote for your zip code.

Local fill dirt in the Fort McCoy area typically comes from nearby quarries, excavation contractors, or recycled site material; Hello Gravel connects you with trusted Marion County suppliers and haulers. Enter your zip code to see avaIlable suppliers, delivery options, and transparent pricing, and we can schedule a dump-truck delivery to your site.

Fill dirt compacts well but does not drain as freely as sand or crushed stone, so on Fort McCoy’s clayey soils and higher water table you should expect slower drainage. For driveways or pads, contractors often add a drainage layer (crushed stone or sand) and install geotextile fabric, or use engineered structural fill to improve performance and reduce saturation risks.

One acre = 43,560 sq ft, so raising it 3 inches requires about 403 cubic yards (roughly 520–540 tons) and 6 inches requires about 807 cubic yards (roughly 1,050–1,100 tons), assuming fill dirt weighs about 1.3 tons per cubic yard. Always add 5–10% extra for compaction and settlement and confirm exact density with your supplier before ordering.

Permitting depends on the scope and location of the project; small landscaping loads usually need no permit, but large fills that change drainage, affect wetlands, are in floodplains, or impact septic systems may require county approval. Contact Marion County Development Services or the local planning office before major deliveries to confirm grading, stormwater, and environmental rules.

For structural fills and driveways in West Florida, use screened, clean fill dirt with low organic matter for general grading, and finish the driving surface with a layer of compactible base (crusher run or 3/4u0022 minus) for strength and drainage. If drainage is a concern, blend in sand or use a crushed-stone base beneath the fill to improve performance in wet seasons.

Contractors in the Fort McCoy area generally prefer screened or engineered (virgin) fill for structural work because it is more consistent and has lower organic content; recycled fill is commonly used for non-structural areas or budget projects. Ask your contractor what spec they require; Hello Gravel can note material preferences in your order to match local practices.

Contractors typically place fill in 4–8 inch lifts and compact each lift using plate compactors, vibratory rollers, or sheepsfoot rollers, aiming for manufacturer or engineer-specified density (often around 90–95% Standard Proctor for structural work). For critical pads or driveways they may perform compaction tests (nuclear gauge or proctor tests) and use excavators, skid steers, and dump trucks for placement.

Measure the area carefully and use our material calculator to estimate cubic yards, then add 5–10% for compaction and settlement; our minimum order is 3 tons, so small jobs may require a fuller load or split deliveries. Note access constraints, request a delivery date during checkout, and add order notes about spreading requests—the driver may be able to tailgate spread at their discretion but it is not guaranteed.