Fill Dirt in Maxville, FL

A typical tri-axle dump truck in the Maxville area carries about 10-12 cubic yards of loose fill dirt. Expect a delivered price range of roughly $200 to $600 per load depending on supplier, distance, moisture content, and access; heavy, wet loads cost more. Hello Gravel requires a minimum order of 3 tons and shows final pricing at checkout for your zip code.

In Florida, fill dirt in Maxville commonly ranges from about $15 to $45 per cubic yard, or roughly $20 to $50 per ton, depending on regional supply and hauling distance. Prices vary with soil type, moisture, and local demand, so check Hello Gravel for the exact landed price for your address.

One cubic yard equals 27 cubic feet. That will cover about 324 sq ft at 1 inch depth or about 108 sq ft at 3 inches depth, so calculate based on the depth you need for grading or fill.

Yes. Fill dirt is generally less expensive than topsoil because it has little to no organic matter and is used for bulk raising and grading. For lawns and planting in Maxville's sandy soils, you should add a 4-6 inch topsoil layer over fill dirt for good plant growth.

If your driveway is 100 ft long and 12 ft wide and you want to raise the base 4 inches, you need about 15 cubic yards of fill (100 x 12 x 0.333 ft = 400 cu ft ≈ 14.8 cu yd). Multiply by local price per yard and add delivery; for many Maxville jobs expect material plus delivery costs.

A 1 cubic yard pile is a cube about 3 ft on each side (27 cu ft). As a loose pile it might look like a low mound roughly 3 ft high and 6–9 ft across, enough to fill several wheelbarrow loads.

Most full-size pickups can carry 1 cubic yard of fill dirt in the bed if you level the load, and some can carry up to 1.5–2 cubic yards with a light heap. Check your truck’s payload rating first—one cubic yard of fill dirt can weigh around 1,500–2,500 lbs depending on moisture, which may approach or exceed some trucks’ limits.

You should not lay sod directly on untreated fill dirt. Fill dirt lacks organic matter and compaction can prevent root growth; for best results in Maxville’s climate add 4–6 inches of quality topsoil over the fill, loosen the surface, and apply starter fertilizer before installing sod.

Yes—fill dirt is commonly used to regrade and raise low spots, but do it in 4 to 6 inch lifts and compact each lift to avoid future settling. Also consider drainage, keep fill away from neighbor properties and wetlands, and in Maxville check local regulations if you are changing stormwater flow or raising elevations significantly.

Yes. Buying fill dirt in bulk by the cubic yard is almost always cheaper per cubic yard than buying the same material in bags. Hello Gravel’s platform connects you with local deliveries so you get bulk pricing plus scheduled delivery—compare the landed price per yard including delivery to bagged costs.

A typical wheelbarrow holds about 3 cubic feet, so one cubic yard (27 cu ft) will be roughly 9 wheelbarrow loads. The exact number depends on the size of your wheelbarrow and how full you load it; expect a range of about 8–12 loads.

Yes. Maxville’s West Florida location means sandy native soils, a relatively high water table in some areas, and hurricane-season erosion risks. Use engineered compaction for structural fills, plan for drainage, avoid filling near protected wetlands, and ask Hello Gravel about delivery access and timing for local conditions.