Fill Dirt in Beach Haven, FL

In Beach Haven, expect delivered clean fill dirt to run roughly $10 to $30 per cubic yard depending on quality, hauling distance, and seasonal demand. Local factors like high water table, screening requirements, or contamination testing can raise the price, so get a local quote for an exact number.

Small orders often carry a higher per-yard price or minimum delivery charges; one yard of fill dirt in Beach Haven can cost more per unit than bulk orders and may trigger a minimum order (Hello Gravel minimums start at 3 tons). Contact us for an exact small-order price and delivery fee before assuming a single-yard rate.

A typical tri-axle dump truck holds about 10 to 12 cubic yards loose, and a delivered truckload of fill dirt in Beach Haven usually ranges from about $250 to $900 depending on yards, material quality, site access, and permit needs. Narrow streets, difficult drop locations, or restricted access can increase cost, so provide photos or site details when requesting a quote.

Generally yes: plain fill dirt (unwashed, unscreened soil) is usually cheaper per cubic yard than washed gravel or crushed stone in Beach Haven because it is less processed. However, the right material depends on purpose—gravel is often required for drainage or driveways, and using the wrong (cheaper) material can cost more in the long run.

Coverage depends on depth. Using typical densities, one ton of fill dirt is about 0.75 to 0.85 cubic yards, so it will cover roughly 80 sq ft at 3 inches deep or about 40 sq ft at 6 inches deep; adjust for compaction and settle-in by ordering 5% to 15% extra for most projects.

It may physically fit in some full-size pickups, but weight is the limiting factor: one cubic yard of fill dirt can weigh roughly 1.2 to 1.6 tons and likely exceeds most truck payload ratings. Check your vehicle’s payload capacity before hauling—if you’re unsure, use Hello Gravel delivery to avoid overloading and safety issues.

Often yes: coastal and flood-prone areas like Beach Haven may have permitting, elevation, or dune-protection rules before you add fill, especially for larger volumes or grade changes near wetlands and shorelines. Check with the Beach Haven building/zoning office and the county environmental agency before ordering, and let Hello Gravel know if permits are required so we can coordinate delivery timing.

Measure the area (square feet) and desired depth (in feet), then use this formula: (area x depth)/27 = cubic yards needed. Round up for compaction and uneven ground, and remember Hello Gravel minimums and delivery options when placing your order—contact our team if you want us to verify calculations.