Fill Dirt in Miccosukee Land Cooperative, FL

Fill dirt is locally sourced subsoil with little to no organic matter used to raise low spots, build grades, or fill holes. In the Miccosukee Land Cooperative area it often reflects regional sandy subsoil and may include clay pockets; it is not designed for planting or landscaping topsoil applications. Use it for structural fill, road base preparation, or under slabs where drainage and compaction are priorities.

Prices vary by supplier, haul distance, and moisture, but in the Florida region a delivered cubic yard of basic fill dirt commonly ranges from about $10 to $30 per cubic yard. For an exact price for Miccosukee Land Cooperative, check your zip code on our site or request a quote since local availability and trucking affect cost. Remember minimum orders may apply.

Yes—generally fill dirt is less expensive than screened topsoil because it lacks organic material and requires less processing. In Miccosukee Land Cooperative you can expect topsoil to cost more per cubic yard because it is blended, screened, and intended for planting, while fill dirt is sold primarily for grading and structural uses. Choose topsoil for lawns and gardens and fill dirt for raising grades or filling voids.

Use fill dirt when you need to raise grade, fill holes, or create a stable base under driveways, foundations, or patios; it compacts well and provides structural support. Use topsoil when you are establishing lawns, gardens, or planting beds because topsoil contains organic matter plants need. In Florida’s sandy soils, avoid relying on fill dirt near root zones—add topsoil or amendments before planting.

Truck capacity varies: smaller single-axle dump trucks often carry about 6–8 cubic yards, tri-axle dump trucks commonly carry about 10–12 cubic yards, and end-dump semis range from 20–25 cubic yards. Because fill dirt density changes with moisture and composition, that translates roughly to 8–10 tons for small trucks, 12–16 tons for tri-axles, and 24–32 tons for semis. Confirm truck type and local weight limits when ordering.

Weight depends on moisture and soil type, but fill dirt commonly weighs about 1.2–1.4 tons per cubic yard in the Florida region. Using that rule of thumb, a tri-axle 10–12 cubic yard load typically weighs about 12–17 tons, while a 20–25 cubic yard semi can weigh roughly 24–35 tons. Always check with your supplier if exact weight matters for permits or spreading.

One cubic yard equals 27 cubic feet and will cover about 324 square feet at 1 inch depth. Since fill dirt in Miccosukee Land Cooperative usually weighs roughly 1.2–1.4 tons per cubic yard, one ton is about 0.7–0.85 cubic yards, which would cover roughly 225–275 square feet at 1 inch depth. For deeper fills, multiply the depth: for example, 6 inches of fill requires about 0.5 cubic yards per 100 square feet.

A semi (end-dump) typically carries about 20–25 cubic yards of fill dirt, and delivered cost can vary widely with distance, availability, and local demand. As a rough estimate for the Florida region, a semi load may range from a few hundred dollars up to around $1,000 delivered; request a zip-code-specific quote on our site for an accurate price. Keep in mind minimum orders, site access, and tailgate spreading requests can affect total cost.

Fill dirt is usually cheaper per cubic yard than most decorative gravels and crushed stone because it is raw subsoil. However, gravel provides better drainage and load-bearing surface for driveways or paths, so gravel may be the smarter investment for those uses. For simple grade-raising or under-slab fill where drainage isn't critical, fill dirt is the economical choice.

Fill dirt is a poor choice where drainage, erosion resistance, or wearing surface is required—such as for driveways, walkways, or areas with standing water during Florida’s rainy season. Gravel resists erosion and provides a permeable load-bearing surface; fill dirt can wash away or become compacted and muddy under heavy rain. Plan for proper subgrade drainage or use gravel where surface stability is important.

Yes—Miccosukee Land Cooperative homeowners should consider high seasonal water tables, local drainage patterns, and any neighborhood or county grading permits before placing large fills. Deep or structural fills near property lines, wetlands, or septic systems may need an engineered plan or county approval. Always mark utilities, check access for dump trucks, and consult local building or environmental authorities if you are moving large volumes.

Order online or call to get a quote, check zip-code availability, and select a delivery date; our minimum order is 3 tons. Prepare your site by clearing an accessible drop location, marking the desired pile area, removing low-hanging branches, and leaving a clear path for tri-axle or semi trucks; add delivery notes for tight driveways or gate codes. Request tailgate spreading at checkout if you want it but note drivers perform spreading at their discretion.