Gravel in Bokeelia, FL

Assuming a single-car 20-ft by 10-ft driveway (200 sq ft) and a 3-4 inch gravel top over a small compacted base, you will need about 2.5 cubic yards (roughly 3.5 tons). Materials and delivery for that amount typically run in the low hundreds of dollars, while professional site prep and spreading can add several hundred more. Expect a rough total range of about $450 to $1,400 depending on gravel type, site access, and whether base work or compaction is required; get a local quote for an exact price.

For 1,000 sq ft, quantity depends on depth: at 2u0022 you need about 6.2 cubic yards (about 8.7 tons); at 3u0022 it's about 9.3 cubic yards (about 13 tons); at 4u0022 it's about 12.3 cubic yards (about 17.2 tons). Delivered material prices in the area vary by type and distance, but you might budget roughly $30 to $75 per ton as a starting point, so materials+delivery could range from about $260 to $1,300 or more. For an accurate total, use Hello Gravel’s calculator or request a quote for your ZIP code.

Prices depend on rock type and distance from the pit; a common range in West Florida is about $30 to $75 per ton, which roughly equals $40 to $105 per cubic yard (1 cubic yard ≈ 1.4 tons). A 10-yard load (about 10 cubic yards) is often used as a standard dump truck load and can cost anywhere from roughly $400 to $1,000 delivered, depending on material and access. Hello Gravel’s site will give a firm delivered price for your address and the 10-yard option during checkout.

Residential delivery costs vary with load size, material, and site access; small minimum orders (Hello Gravel minimum 3 tons) will usually have a higher per-ton price than full truckloads. A typical delivered load for a residential job might run from a few hundred dollars for small loads up to $800–$1,200 for larger, specialty, or long-haul deliveries. Extra charges can apply for narrow driveways, off-road deliveries, or required permits, so check your quote and add order notes for special access needs.

Two inches is too thin for a driveway in Bokeelia’s sandy coastal soils and rainy climate; it will wash out or rut under vehicle traffic. Pros typically recommend a compacted base of 6 to 8 inches of crushed stone or crusher run, topped with 3 to 4 inches of compactable gravel for a finished surface, along with geotextile fabric for separation and improved drainage. Proper grading, drainage swales, and edge restraint are also important given local heavy rain and hurricane season.

A crushed stone mix with fines (often called crusher run or 3/4u0022 minus) gives good compaction and durability for driveways in West Florida; #57 or 3/4u0022 crushed stone is a common top layer when combined with a crusher-run base. Near the coast you may encounter shell or coquina mixes; these are less durable under heavy traffic and can break down faster, so discuss options with your supplier. Always note local salt exposure and wet conditions—dense, angular crushed stone with fines holds up better than round pea gravel in this climate.

One cubic yard equals 27 cubic feet and will cover about 324 sq ft at 1u0022 depth, 162 sq ft at 2u0022 depth, and 108 sq ft at 3u0022 depth. Because gravel density varies, 1 cubic yard typically weighs about 1.3 to 1.5 tons; using 1.4 tons per cubic yard is a good rule of thumb, so one ton covers roughly 115 sq ft at 2u0022 or about 77 sq ft at 3u0022. Use these conversions or Hello Gravel’s calculator to estimate how many tons you need, and remember our minimum order is 3 tons.

Yes—options include polymeric binders, resin-bound systems, and gravel grid pavers that stabilize loose stone and create a firmer surface. These systems cost more than loose gravel: expect roughly $5 to $12 per sq ft installed depending on the product and prep work, versus $1 to $4 per sq ft for loose gravel installation. Stabilized surfaces work well in wet climates like West Florida but require proper base prep and local contractor quotes to determine final cost.

A 20x20 area is 400 sq ft. At 2u0022 depth you need about 2.5 cubic yards (≈3.5 tons); at 3u0022 about 3.7 yd3 (≈5.2 tons). Materials and delivery for that range might cost roughly $150 to $500, and professional spreading or site prep can add $150 to $600 depending on site access and whether base work is needed, so a totalballpark of $300 to $1,100 is reasonable—get a quote for precise pricing.

Low-maintenance options include decomposed granite, crushed limestone or crushed stone with fines, and pea gravel in low-traffic planting beds; use landscape fabric and edging to control migration. For planting beds and walkways expect material+delivery costs generally under $2 per sq ft for loose gravel; professional installation including prep, edging, and weed control commonly ranges from $2 to $6 per sq ft. Always choose materials and depth suited to coastal weather and drainage, and ask suppliers about shell content if you prefer a long-lasting surface.