Fill Dirt in Keene, TX

Hello Gravel requires a 3-ton minimum order. Standard delivery is generally 2+ business days and next-day delivery is available for orders placed before noon CST for an additional fee. Delivery fees often depend on supplier distance and may be free in many areas, so check the quote at checkout for the exact cost to Keene.

Fill dirt in Keene can be affected by local clay and the hot, dry climate: clay-rich fills may shrink and crack during dry spells and swell when wet. For stable results, compact in lifts and pay special attention to drainage to avoid water pooling that can cause long-term settling or movement.

For general fill use, pick a well-graded mix with mostly fine material and small clods (no large boulders), with maximum pieces generally under 2-3 inches. Compact in 6- to 8-inch lifts using a plate or roller to achieve high density (contractors often target roughly 90% or higher of standard Proctor density); note that a crushed-stone base is still recommended for the structural layer of a driveway.

As a rule of thumb, 1 cubic yard = 27 cubic feet and typical fill dirt weighs about 1.2–1.4 tons per cubic yard (use 1.3 tons/yd3 as a working average). For 1,000 sq ft: 1 inch of fill = ~3.1 cu yd (~4.0 tons); 6 inches = ~18.5 cu yd (~24 tons). Always add 5–10% for compaction, settlement, and waste and use our material calculator or request a supplier estimate for a precise quote.

Small, minor fills around a yard often do not require permits, but anything that changes drainage, creates a building pad, or involves retaining walls may trigger City of Keene or Johnson County permitting. Check with the City of Keene building/permits office and Johnson County before major grading, and watch for floodplain, setback, and drainage easement rules that could affect your project.

Hello Gravel connects you to trusted local suppliers that deliver to Keene; the exact supplier will be shown during checkout when you enter your zip code. Deliveries are typically made with tri-axle dump trucks (commonly carrying about 10–16 tons) or other local haul trucks; delivery fees vary by distance and truck routing, so request a quote in checkout for the most accurate price.

Fill dirt is designed to raise grade and fill voids and tends to contain fines that do not drain well, so it is not a good final structural base for driveways. Crusher run or quarry run are crushed stone mixes that compact tightly while allowing better drainage and are a better choice for a driveway base in Keene’s clay soils and occasional heavy rains.

Proper compaction is done during installation in lifts; after final compaction, light work may proceed in 24–72 hours, but paving or building often requires a proof roll and sometimes lab or field compaction tests to verify density. For building pads or structural work, follow your engineer’s recommendations—in some cases waiting days to weeks for moisture equilibration and testing is necessary.

Fill on slopes in West Texas should be stabilized with seed, mulch, erosion-control blankets, or retaining structures to reduce washout during storms. Inspect slopes after heavy rains, regrade low spots as needed, and install permanent drainage improvements (swales, French drains) to reduce ongoing erosion and settlement.

Yes, suppliers can often blend fill dirt with sand, gravel, or crushed rock to improve drainage and compaction, or add topsoil where you plan to plant. Tell us your intended use at checkout or call our team so we can match you with the right blend for Keene’s soils and your project goals.