Fill Dirt in Liberty, TX

Prices vary by supplier and delivery distance, but in Liberty you can expect fill dirt material to range roughly $10 to $25 per ton with delivery adding $50 to $200 for small local runs. A typical tri-axle dump truck carries about 10-12 cubic yards (roughly 12-16 tons depending on moisture), so a delivered truckload commonly runs in the low hundreds of dollars. Get an exact quote for your zip code at checkout since local supply and truck access change price.

Yes. Fill dirt is usually less expensive than decorative or structural gravels because it is used for bulk filling rather than finished surfaces. For driveways or grading in Liberty, use fill dirt to raise grade or fill holes, then cap with gravel or crushed stone for a durable driving surface.

Use this quick guide: for 1,000 sq ft you need about 7.4 tons at 2u0022 depth, about 14.8 tons at 4u0022 depth, and about 22.2 tons at 6u0022 depth. A common tri-axle truck holds roughly 12-16 tons, so 4u0022 depth is about one full truckload in many cases, while 6u0022 is about one and a half loads. Always round up and allow extra for compaction and settlement.

Cost depends on width and depth, but for a 20-ft by 10-ft single-car area (200 sq ft) at a 4u0022 depth you need about 3 tons of fill dirt. Expect material plus delivery and minimal spreading to range from about $60 to $200 total in Liberty, depending on supplier rates and whether you request tailgate spreading. For precise pricing, enter your zip code or call our team for a local quote.

Two inches of fill dirt is not sufficient as a base for a driveway. For long-term performance in West Texas, plan on at least 4u0022 of compacted fill dirt as a building layer, and 6u0022 to 8u0022 if you expect heavier vehicles or poor subsoil; always compact in lifts and consider a crushed-stone wearing layer on top. Also consider geotextile fabric in soft or wet areas to improve stability.

Approximate coverage for 1 ton of local fill dirt: about 135 sq ft at 2u0022 depth, 90 sq ft at 3u0022 depth, 67.5 sq ft at 4u0022 depth, and 45 sq ft at 6u0022 depth. These are rounded estimates based on typical local densities; actual coverage varies with moisture content and compaction. Order a little extra (5-10%) to allow for settlement and grading adjustments.

The most economical approach is to order material by the ton through a delivery service like Hello Gravel and do the spreading yourself if you have tools or equipment. If you need placement help, request tailgate spreading at checkout (driver discretion) or hire local labor or equipment (skid steer/small excavator) which may still be cheaper than full contractor installation for small jobs. Compare per-ton pricing and delivery fees for the best local deal.

Fill dirt should not be used as a finished driveway surface. It is intended for raising grade and backfilling; it compacts but does not provide a durable, low-maintenance driving surface. For finished driveways choose crushed stone, crusher-run, or other structural aggregates over a compacted fill-dirt base, and avoid fill dirt in low spots or areas prone to standing water.

Because Hello Gravel sources locally, fill dirt in Liberty may include clay, sand, or caliche depending on the supplier and exact location. Clay or caliche-rich material can compact well but may hold water or be harder to grade, while sandy fill drains faster but compacts less. Tell your rep about your project so they can recommend the right blend and advise on compaction and drainage for West Texas conditions.

Measure your area, choose a target compacted depth, and use our material calculator or the simple formula (area x depth / 27) to get cubic yards, then convert to tons (roughly 1.2 tons per cubic yard for local fill dirt). Order at least 5-10% extra to account for settlement and grading, place your order early to secure delivery date, and contact our team if you need help changing quantities before dispatch.