Fill Dirt in Cooke County, TX

Fill-dirt is clean, non-organic soil used to raise or level a site, build pads, or fill low spots. In Cooke County you’ll use it to build driveways, raise building pads above wet clay, or bring a yard to grade before landscaping. It is not a finished driveway surface; add compacted base rock or surface stone for driving areas.

A good rule of thumb in Cooke County is about 1.3 tons per cubic yard for typical fill-dirt, with a realistic range of 1.2 to 1.4 tons depending on moisture and compaction. If your site is very wet or the dirt is heavier clay, expect toward the higher end. Always round up slightly to allow for compaction and waste.

Delivery rates vary by supplier, haul distance, and load size, but rural Cooke County customers typically see delivered prices in a broad range. Material plus delivery often falls in a range where the material itself may be low-cost but trucking adds most of the fee, so expect variability and get a quote for your zip code. Hello Gravel will provide local pricing and show any delivery or minimum-order details (note our platform minimum is 3 tons).

Hello Gravel partners with local dirt yards, contractors, and haulers serving Cooke County and nearby North Texas areas; availability depends on your exact zip code. Many suppliers can deliver and some drivers may do tailgate spreading at their discretion, but spreading is not guaranteed and is evaluated on arrival for safety and access. Use Hello Gravel to check suppliers for your address and request spreading in the Order Notes.

Cooke County has clay-rich soils that swell and shrink with moisture, so poorly prepared fill can settle or heave after heavy rains. For driveways and structural pads, you should use clean, compacted fill-dirt, control surface drainage, and place base rock or engineered fill where needed to reduce movement. For critical structures consider geotechnical advice or stabilization (lime or cement) if expansive clay is present.

Costs depend on material price, haul distance, compaction, and equipment. As a rough guideline, expect material plus delivery and basic spreading/compaction to vary widely; get multiple quotes, but homeowners often see total installed costs quoted per cubic yard or per ton rather than per project. Hello Gravel can get you local delivered-material pricing and you should add contractor bids for spreading and compaction to get a full installed price.

Rules vary by project type and location. For small landscaping fills most homeowners do not need a county permit, but building pads, septic fields, or large grading projects may require permits or zoning approval from Cooke County or local municipalities. Before importing large quantities, check with Cooke County permitting or your city planning office and confirm landfill or borrow-site rules if material is coming from outside the region.

Ask for clean fill free of roots, vegetation, garbage, and large debris, with a well-graded mix of fines and sand that compacts well; avoid organic topsoil when you need structural fill. For driveways, plan to place compacted fill in 6- to 8-inch lifts and cap it with 4-6 inches of compacted base rock (3/4-inch minus or similar) for a stable surface. For erosion-control uses, discuss blended mixes or rock armoring with suppliers and contractors to match slope and drainage conditions.

Rates vary by contractor, equipment, and job complexity; common billing methods are per hour for equipment operators, per cubic yard for installed material, or per load for trucking. Typical local charges can include a per-load trucking fee plus $75-$150 per hour for an operator and machine for spreading and compaction, but these numbers vary so get written quotes. Hello Gravel can supply delivered material pricing; you should pair that with local contractor bids for a complete job estimate.