Gravel delivery in Falmouth, VA

Expect a wide range depending on type and distance: common base gravels often run about $25 to $60 per ton delivered to the Falmouth area, while decorative gravels and pea gravel can be $40 to $90 per ton. Hello Gravel has a 3-ton minimum order; delivery fees vary by supplier and distance, and in many areas we offer free delivery — check your zip code for exact pricing.

For Falmouth's clay/loam, use a well-graded crushed stone (example: 3/4u0022 crushed stone or #57) for a stable base, topped with 3/8u0022 to 1/2u0022 crushed stone or stone screenings for a compactable surface. Pea gravel is comfortable for pathways but tends to move under vehicle traffic, so it is not ideal as a driveway surface without edge restraint and a compacted base.

Using common conversion assumptions (about 1.4 tons per cubic yard), expect roughly: 2u0022 depth = 9 tons per 1,000 sq ft, 3u0022 depth = 13 tons per 1,000 sq ft, and 4u0022 depth = 17 to 18 tons per 1,000 sq ft. These are estimates — actual tons vary with gravel type and compaction, so order a little extra for settling and grading.

Gravel performs well if the subgrade drains and the driveway has a crown and good drainage; humid summers can cause rutting from heavy storms and freeze-thaw cycles can create potholes. Proper base preparation, periodic regrading, and adding fresh stone after winters will reduce erosion and extend the surface life.

Installed cost varies with prep and access but a common range is $1.50 to $4.00 per square foot, which means a small driveway often costs roughly $2,000 to $6,000 installed. Complex jobs with heavy grading, drainage work, or geotextile can be more expensive, so get local quotes for accurate pricing.

Hello Gravel works with a network of regional quarries and haulers that deliver to the Falmouth area; many local suppliers have minimum deliveries of 3 to 5 tons for standard dump trucks, while some quarries have larger minimums for bulk loads. Enter your zip code on our site or contact our team to see the exact suppliers, available products, and minimums near you.

Plan on light maintenance once a year (regrading and filling low spots) and more substantial material top-ups every 2 to 3 years. For a typical driveway you might add 1 to 3 tons per 1,000 sq ft over a year or two; annual costs for basic upkeep if DIY are often under $100 in materials, while contractor maintenance runs from a few hundred to $1,000 depending on scope.

Yes — gravel is well suited for sloped sites and swales when sized and installed properly. Use larger angular stone (example: 3/4u0022 to 1-1/2u0022) for base layers and #57 (about 3/4u0022) for swales or channel flow to prevent migration; add geotextile fabric and check-dams or riprap on steeper slopes to control erosion.

Gravel has the lowest upfront cost but higher ongoing maintenance; asphalt is mid-range in cost and gives a smoother, lower-maintenance surface but needs periodic sealing and resurfacing; concrete costs the most up front but lasts longest with the least frequent major maintenance. Also check local stormwater and impervious surface rules in Stafford County or your jurisdiction, as those rules can affect long-term compliance for paved surfaces.

Some HOAs and local zoning rules do restrict the appearance or materials of driveways, and restrictions vary by neighborhood and county. Before installing, check your HOA covenants and contact Stafford County zoning or your local permitting office to confirm if gravel is allowed and whether edging, stabilization, or grading permits are required.