Fill Dirt delivery in Alexandria, VA

Fill dirt is generally less expensive per ton than decorative gravel because it is a basic soil material without stone sizing or washed fines. Prices vary by local supply and delivery, so check Hello Gravel for up-to-date, zip-code-specific pricing and remember our minimum order is 3 tons.

Fill dirt is fine-grained soil used to raise or level ground, while gravel is crushed rock used for drainage and durable surfaces. In Alexandria, use fill dirt to build grade and then cap with gravel or topsoil depending on whether you need drainage or a finished planting surface.

One ton of fill dirt in the Northern Virginia area is roughly 0.8 cubic yards and will cover about 270 square feet at a 1-inch depth. Allow extra material for compaction and settlement—plan on ordering 5-15% more for small raises and up to 25% more for loose, uncompacted fills.

Fill dirt can be used to raise or level the subgrade of a driveway but it is not a durable surface on its own. For a lasting driveway in Alexandria you should compact the fill, add several inches of base stone or crushed rock, and finish with the appropriate surface material (crushed stone, asphalt, or pavers).

Volume depends on depth. For example, 1,000 sq ft at 4 inches needs about 10 cubic yards (roughly 12–13 tons); at 6 inches it needs about 15 cubic yards (roughly 18–20 tons). Use Hello Gravel’s material calculator for a precise, zip-code-based estimate and include extra for compaction.

Cost varies by supplier, moisture content, and delivery distance, so prices change frequently. For an exact, current per-ton price and delivery options in Alexandria, enter your zip code on Hello Gravel or contact our team for a quote; remember many areas have free or flat-rate delivery.

It depends on driveway width and desired depth. For a 100 ft by 12 ft driveway raised 4 inches you’d need about 14.8 cubic yards (roughly 18 tons); if you need a 6-inch raise, plan on about 22–24 tons. Factor in compaction and always verify site conditions before ordering.

Hello Gravel commonly uses tri-axle dump trucks that deliver about 10–12 cubic yards of material (roughly 12–15 tons for fill dirt, depending on moisture). At a 6-inch finished depth that equates to about 540–650 square feet; at a 1-inch depth one load covers much more—about 3,200–3,800 square feet.

You can place gravel over fill dirt, but only after proper preparation: compact the fill, check and correct drainage, and consider a geotextile fabric to prevent mixing. Without proper compaction and a stable base, gravel will settle and rut in the region’s freeze-thaw and rainy seasons.

Yes—fill dirt is commonly used to level yards and raise low spots, but do it in thin lifts (6–8 inches) with compaction between lifts to reduce settlement. Also check for underground utilities, consider permit requirements for large fills in the City of Alexandria, and add topsoil if you plan to grow grass or plants.

No, 2 inches of fill dirt is not sufficient for a driveway or patio base; thin layers settle and won’t provide support. Standard practice is to place and compact several inches of structural fill and then add a 4–6 inch compacted stone base before any surface material.

No, compacted fill dirt will become firmer but it will not harden like concrete. For a rigid, paved surface you need engineered base materials (crushed stone, stabilization additives, or concrete/asphalt); compacted fill is meant for grade and support, not a finished hard surface.