Fill Dirt delivery in Brownsville, TX

Typical delivered prices in Brownsville usually fall in the range of about $10 to $20 per ton, which converts roughly to $12.50 to $25 per cubic yard using a 1.25 tons/yd3 estimate. Prices vary by supplier, distance to the site, and seasonal demand, so get quotes in checkout to see exact pricing for your zip code.

Most Brownsville suppliers working through Hello Gravel follow a 3-ton minimum order, which is our national minimum as well. Standard delivery is usually free or included for nearby loads with a 2+ business day lead time, while next-day delivery may be available for an extra fee if ordered before noon CST; long-distance or specialty deliveries can carry additional charges.

For Brownsville’s coastal conditions, choose clean, low-organic fill with a sandier content to improve drainage; a general yard-fill blend might be approximately 60% sand, 30% loam/silt, and 10% clay, though exact mixes vary by supplier. For structural work like building pads, use engineered compactable fill or specify a granular base beneath the fill and consult a geotechnical engineer to pick the right blend for your site and water table.

Homeowners use fill dirt in Brownsville to raise yard grades, re-slope for drainage, or add non-structural fill under patios and landscaping. Best practices include placing fill in thin lifts (6 to 12 inches), compacting each lift, keeping organic material out of fill, and adding a granular base or geotextile plus crushed stone for driveways and building pads to handle the local high water table.

Use this simple formula: cubic yards = (square feet * inches of fill) / 324. Then convert to tons by multiplying cubic yards by about 1.25 (tons per cubic yard for typical fill dirt). For example, raising 1,000 sq ft by 4 inches needs ~12.35 yd3, or roughly 15.4 tons of fill dirt.

Yes. Brownsville and Cameron County have grading, floodplain, and stormwater requirements that can apply to significant fills, especially near wetlands, creeks, or within regulated coastal zones. Before placing large volumes of fill, check with the City of Brownsville Building and Planning Departments or a local permit specialist to confirm permit needs and required erosion-control measures.

Fill dirt will compact well if it is low in organics and placed in proper lifts, but clayey fills common in the region can hold water and drain poorly. Crushed stone or base rock provides much better drainage and load-bearing capacity, so for driveways and structural pads in Brownsville’s high water table areas, a granular base or crushed-rock layer is usually recommended over relying on fill dirt alone.

Hello Gravel connects you with local suppliers and haulers in Brownsville; standard delivery lead time is 2+ business days and next-day delivery is sometimes available for orders placed before noon CST. Placement, tailgate spreading, and compaction services may be offered by some local suppliers or third-party contractors for an additional fee, but drivers perform tailgate spreading only at their discretion and compaction is not guaranteed unless arranged as a contractor service.