Fill Dirt delivery in Metairie, LA

Fill-dirt is inexpensive earth material used to raise or level ground; it usually contains subsoil and little organic matter. Gravel is a crushed stone aggregate used for drainage and surfaces; gravel drains better and carries loads, while fill-dirt is for bulk elevation and backfill.

Generally yes — fill-dirt usually costs less per cubic yard than decorative gravel because it is a basic subsoil product. Prices vary by supplier and moisture content, so get a quote from local Metro-area suppliers and factor in delivery to Metairie.

One cubic yard of fill-dirt typically weighs about 1.2 to 1.5 tons, depending on moisture and compaction. Weight varies by source, so use that range when planning truck capacity or comparing quotes.

Yes — fill-dirt is commonly used to level yards, but it should be placed in thin lifts (6 to 8 inches) and compacted between lifts to minimize future settlement. Because Metairie has a high water table and heavy rains, ensure proper grading away from structures and consider a pro for fills near foundations.

You can put gravel over fill-dirt, but only after the fill is properly compacted and graded. If you skip compaction the gravel will sink and rut; a geotextile fabric and a compacted base layer improve performance and longevity.

Start with properly compacted fill-dirt, then add a 3 to 6 inch crushed stone base depending on use, and consider geotextile fabric to separate soils and prevent mixing. This is especially important in Metairie where wet soils can migrate into stone and reduce drainage.

Use the formula: cubic yards = area (sq ft) x depth (inches) / 324. For example, raising 1,000 sq ft by 2 inches requires about 6.2 cubic yards; always add 10 to 20 percent for compaction and settlement.

Fill-dirt can settle over time if not properly placed and compacted, may contain clay that holds water, and is poor for plant growth because it lacks organic matter. In coastal Louisiana, added risks include washout during heavy storms and changes to drainage patterns, so erosion control and proper grading are important.

You may need permits for large fills or when changing site elevation near flood-prone areas; Jefferson Parish and local zoning rules apply. Check with Jefferson Parish permitting and the local floodplain administrator before major fills, especially in FEMA flood zones.

For structural backfill or near foundations, order clean, well-graded fill (low organics, minimal debris) and follow compaction specs from your engineer or contractor. For general landscaping or raising grade, less refined fill-dirt is acceptable, but top with topsoil where you plan to plant.

Hello Gravel coordinates local suppliers and delivers by dump truck (typically tri-axle). Our minimum order is 3 tons; standard delivery is 2+ business days with a next-day option if ordered before noon CST, and tailgate spreading is available only at the driver's discretion.

Some settlement begins immediately and can continue over months; proper compaction during installation greatly reduces long-term settling. Place fill in thin lifts and compact each lift to the specification required for your project to get stable results.

Mixing is not recommended for planting beds; fill-dirt lacks organic matter and nutrients needed for plants. Instead, place 4 to 6 inches of quality topsoil over compacted fill-dirt for lawns and gardens to ensure healthy plant growth.

Stabilize slopes immediately by shaping grades to slow runoff, seeding with grass, or using erosion-control blankets and silt fences on exposed soil. For larger projects consider installing temporary drainage controls and consult local best practices for storm season.