Fill Dirt in Port St. Lucie, FL

Delivered prices in Port St. Lucie typically vary based on material quality and haul distance. Expect a rough range of $15 to $45 per cubic yard (or about $20 to $55 per ton) delivered, though exact pricing depends on supplier, whether the dirt is screened, and truck access. Hello Gravel has a 3-ton minimum and provides clear quotes and delivery scheduling—ask for a local quote to lock in a price.

Yes, fill-dirt is generally cheaper per cubic yard than crushed stone or decorative gravel because it is a lower-grade material used for raising grade and backfill. However, for surfaces that need drainage, compaction, or load-bearing capacity (like driveways), gravel or crushed stone is usually the right choice and may cost more but performs better. Always compare total project costs, including compaction and drainage, not just material price.

In Port St. Lucie, delivered cubic-yard prices for basic fill-dirt commonly fall between $15 and $40 per cubic yard, depending on whether the dirt is screened, clean, or mixed with sand. Local hauling and access, plus any spreading services, will affect the final cost. Use Hello Gravel to get a site-specific delivered price for your zip code.

One ton of typical Florida fill-dirt is roughly 0.8 to 0.9 cubic yards depending on moisture and compaction. At that rate, 1 ton covers about 270 to 290 square feet at 1-inch depth, about 90 to 97 square feet at 3-inch depth, or about 45 to 48 square feet at 6-inch depth. Use these numbers to estimate coverage for your intended depth.

Volume depends on depth: for 1,000 sq ft at 2 inches depth you need about 6.2 cubic yards (roughly 7.5 to 8.5 tons). At 4 inches you need about 12.3 cubic yards (roughly 14.5 to 16 tons), and at 6 inches about 18.5 cubic yards (roughly 22 to 24 tons). Multiply the cubic yards by local unit price or request a Hello Gravel quote for an exact delivered cost estimate.

The most cost-effective options are reuse of onsite excavated soil, sourcing local native fill from a nearby site, or ordering bulk delivery rather than many small loads. Coordinating deliveries through Hello Gravel can reduce hauling costs and meet the 3-ton minimum efficiently. Avoid premium screened topsoil or special blends if your use only requires basic fill.

A typical tri-axle dump truck carries about 10 to 14 cubic yards of fill-dirt. At 3 inches depth that translates to roughly 1,080 to 1,512 square feet covered; at 6 inches it covers roughly 540 to 756 square feet. Exact capacity varies by truck type and local hauling rules—confirm with your supplier.

A full-size pickup bed can usually hold about 1 to 1.5 cubic yards if loaded carefully, but weight is the bigger concern: one cubic yard of fill-dirt can weigh about 1.1 to 1.3 tons and may exceed your truck’s payload. Check your truck’s payload rating before hauling soil and consider ordering delivery if you are near that limit or want to avoid multiple trips.

Yes—fill-dirt is commonly used to raise grade and improve site slope, but it should be placed in thin lifts and compacted if the area will support structures or pavement. In Port St. Lucie’s sandy soils and higher water table, proper drainage and compaction are especially important to avoid settling or water pooling. For significant grade changes or near foundations, consult a pro or local building department.

The cheapest option locally is usually unscreened native fill or recycled construction fill that has not been cleaned or blended. It is fine for general grade-raising and subgrade fill, but may contain roots, debris, or organics that can cause settling—avoid using it where structural support or final grade stability is required. If you need clean, compactible fill, pay more for screened or engineered fill and ask suppliers for material descriptions.

No. Fill-dirt is not a substitute for concrete or a proper compacted aggregate base for driveways because it lacks the strength, drainage, and stability needed to carry vehicle loads. For driveways and pads use a compacted crushed stone base and consider geotextile fabric; use fill-dirt only for grade adjustments or landscaping berms. If budget is a concern, get a local contractor or Hello Gravel quote for base materials rather than relying on dirt alone.

Calculate volume first: truck cubic yards x 27 = cubic feet, then divide by desired depth in feet (for example, 0.25 ft for 3 inches). Example: a 12 yd3 truck = 324 ft3; at 3 inches (0.25 ft) it covers about 1,296 sq ft. Use that formula with the truck capacity your supplier gives to get an accurate coverage estimate.

A delivered dump-truck load of basic fill-dirt in Port St. Lucie commonly runs between $200 and $800 depending on truck size, material quality, and haul distance. Smaller or screened loads cost more per cubic yard; local access and disposal of excess material can increase the price. For an exact figure, request a Hello Gravel quote that includes delivery details and any optional services.

Local rules vary: minor landscaping changes usually do not need permits, but large grade changes, adding fill in flood zones, or altering drainage often require permits or engineering review. Port St. Lucie and St. Lucie County have regulations around fill in wetlands and floodplains, so check with the city or county building and planning department before major fills. When in doubt, consult local officials or a licensed contractor to avoid fines or required remediation.