Fill Dirt in flovilla, GA

In small West Georgia towns like Flovilla, raw fill dirt typically runs in the low tens of dollars per ton (commonly quoted roughly $10-$30/ton), with local variation based on supplier and moisture content. Delivery fees depend on distance and truck size; expect short local hauls to add about $75-$200 per truckload. Hello Gravel requires a 3-ton minimum and will show local pricing and delivery options at checkout.

Flovilla’s clay-rich soils and humid subtropical climate mean fill dirt can hold moisture and become sticky when wet, making compaction and drainage more important. For structural fills and driveways you should design grade and drainage first, compact in lifts, and avoid using untreated fill dirt at the final surface where standing water is likely.

Hello Gravel’s minimum order is 3 tons, which covers most small patch jobs. Common delivery trucks in the area are tri-axle dump trucks that carry roughly 10-12 tons per load; suppliers may run smaller straight trucks for tight jobs. Suppliers commonly deliver within 20-50 miles of their yard, but exact radius and fees vary by supplier and will be shown during checkout.

Loose, uncompacted fill dirt typically settles between about 10% and 25% of the loose depth, depending on moisture and soil type. For example, a 6-inch loose lift might settle roughly 0.6 to 1.5 inches; deeper fills or organic soils can settle more. For predictable results, place and compact fill in lifts and allow time for consolidation before finishing the surface.

For driveways, crusher run or 3/4" crushed stone with a compacted base is a better wearing surface than raw fill dirt. For engineered structural fills, ask for compacted, tested engineered fill or clean fill; for planting areas and lawns, use screened topsoil rather than fill dirt. Sand can help with drainage in specific situations, but check local soil conditions because clay subgrades in Flovilla may need geotextile and proper drainage too.

Typical estimates using 1.2 tons per cubic yard as a rule of thumb: a 100 ft x 10 ft driveway with 4 inches of fill needs roughly 12-15 tons; the same driveway at 6 inches needs about 20-25 tons. A 12 ft x 12 ft patio at 4 inches is about 2 tons, and a 10 ft x 10 ft low spot filled 6 inches is around 2-3 tons. Use Hello Gravel’s calculator or contact our team for a site-specific estimate.

Yes, contractors typically compact fill dirt here before topping or paving. For small areas they commonly use plate compactors or jumping jack tampers in 3-6 inch lifts; for larger fills contractors use a small vibratory roller and place 4-8 inch lifts, compacting each lift. Always have the contractor assess moisture content because overly wet or dry soil compacts poorly.

Heavy rain in the humid West Georgia climate can cause erosion, washouts, and loss of fines from loose fill dirt, while wetting and drying cycles lead to consolidation and some movement. Freeze/thaw cycles are less extreme here than up north but can still cause minor heaving in exposed fills. Good drainage, proper compaction, and erosion controls (seed, straw, silt fence, or rock) reduce long-term problems.

Yes—Flovilla is a small city inside Butts County, and many projects that change grade or add large fills may trigger city or county permitting, stormwater, or floodplain requirements. HOA rules may also restrict visible fill, driveway surfacing, or truck access. Contact Flovilla City Hall or Butts County building/stormwater offices and review any HOA covenants before ordering large loads.

If fill dirt is used as the surfacing material it will require frequent regrading, compaction, and additions of material after heavy rain; it is not a durable wearing surface. For driveways, plan to top with crusher run or stone and regrade annually or after major storms; for yard fills, allow time for settlement and recompact or add soil as needed before planting. Budget for occasional material additions and erosion repairs in the humid West Georgia climate.

Drivers may be able to perform tailgate spreading at their discretion, and you can request it at checkout, but spreading is not guaranteed and depends on site access and safety. If spreading is required, note it in Order Notes and be prepared to hire local labor or equipment for more precise grading and compaction. Hello Gravel coordinates delivery logistics and can help you plan the best approach.

Clear the dump area of vehicles, low-hanging wires, and obstacles and mark any underground utilities and property lines before delivery. Provide a clear drop zone for the truck with room to back up and a firm surface for truck weight; let the driver know special instructions in advance. For larger or structural fills, arrange for compaction equipment or a contractor to follow the delivery so material is placed and compacted promptly.

As of today, we require 2 business days for delivery.

Use our material calculator here: https://hellogravel.com/calculator/ to enter the length, width and depth measurements of your project. It will automatically calculate the cubic yards/tons needed. If you are unsure how much to order, contact our team for guidance.

Please type in your zip code on any product screen and it will let you know if we service your area. The chances are that we do!

The material will be delivered via dump truck. If your order is under 20 tons, then it will likely be just one dump truck load. If your order is more than 20 tons, it will be more than one dump truck load.

Absolutely! Try our aggregate quiz here: https://hellogravel.com/aggregate-quiz/ Alternatively,you can call us, chat with us (box in the bottom right corner of the website), or email us!

We cannot get out of the truck and manually spread it. However, depending on the location, safety, and comfortability of the driver – we may be able to tailgate spread your material. This involves pulling the truck forward as material is being dumped to make it easier for you to distribute material after delivery.

The minimum order size is 3 tons.

Hassle Free! Our goal is to make the buying process for gravel and other aggregates as easy and seamless as possible. Enter your zip code on our site, select how much material you need (see below FAQ’s to determine order size), select the date and time frame you would like your material delivered at Checkout, and place your order with any major credit card. After the order is placed our in-house support team will contact you to confirm the details. We will send additional confirmations on the day before and the day of delivery. On delivery day, a dump truck will arrive to dump the materials at your specified location. We request that you have someone available to accept the delivery so that we can make sure to dump it in the correct location. That’s it!

No, because we are a national supplier, we utilize our existing network of suppliers across the country. Therefore, the materials will likely be delivered from a contracted trucking company.

We specialize in making the aggregate buying process as easy and seamless as possible by managing the process from end to end. We have a network of suppliers that we source the materials from where we have negotiated rates. However, we do charge a markup and because of this you may be able to find the materials cheaper on your own. But if you want a hassle free experience, then we are for you!

Please fill out the Quote Request form and we will work up a quote for you! https://hellogravel.com/quote-form/

Although uncommon, due to regional sourcing, the type and color of our materials may vary somewhat from the images on our website, reflecting the unique geological offerings of your area. Please communicate any specifications you desire to our team so we can consider them during the sourcing process.

Please contact our customer service team promptly if you experience any delivery or product quality issues. We will work to resolve them satisfactorily.

We are headquartered in New Orleans, LA. However, we have a network of suppliers across the country from which we provide the materials.