Fill-dirt in Windsor, PA

Typical delivered fill-dirt prices near Windsor, PA range roughly $10 to $35 per cubic yard (about $12 to $45 per ton) depending on supplier, material quality, and distance. Delivery is often included inside a local zone, but longer hauls, tight access, or requested spreading can add $50 to $200 or more. Placement (grading/compaction) is usually extra and depends on crew time—ask for a quote with labor included and note Hello Gravel’s 3-ton minimum.

For 1,000 sq ft at a 4-inch depth you need about 12.4 cubic yards of fill-dirt (roughly 15.5 tons). Material-only delivered at $15 to $30 per cubic yard would be about $185 to $370, while adding grading and compaction typically increases total cost to roughly $600 to $2,000 depending on site difficulty and contractor rates. A 20-foot-wide driveway of the same footprint will be similar; get site-specific quotes because slopes, access, and drainage change labor needs.

Yes, fill-dirt is commonly used to level yards and build up low areas, and it can serve as a subgrade for driveways if properly compacted. For a driveway, we recommend compacting fill-dirt in lifts and topping with a structural aggregate (for example crusher run or 3/4u0022 crushed stone); a geotextile fabric is often helpful where soils are wet or soft to separate fill from native soils and reduce mixing. Avoid using fill-dirt as the finished driving surface because it typically ruts and drains poorly.

At minimum remove organic topsoil and vegetation from the area where fill will go, slope the site for positive drainage away from foundations, and call 811 to mark utilities. Place fill in 6u0022 to 12u0022 lifts and compact each lift with appropriate equipment for the intended use; neglecting compaction will cause future settling. If you are unsure about drainage or load-bearing needs, consult a contractor before delivery to avoid rework.

Use the rule of thumb cubic yards = (area in sq ft * depth in inches) / 324. For 1,000 sq ft that equals about 6.2 cubic yards (≈7.8 tons) at 2u0022, 12.4 cubic yards (≈15.5 tons) at 4u0022, and 18.5 cubic yards (≈23.1 tons) at 6u0022—tons shown use a typical conversion of ~1.25 tons per cubic yard, which can vary with moisture and soil type. Always order a small extra amount (5% to 10%) to allow for compaction and grading.

Windsor and surrounding townships may require permits if your project changes drainage, alters a floodplain, or involves significant grading, so check with the local borough or township office before ordering large volumes. Also contact the county conservation district for erosion and sediment controls if the site is sloped. Seasonally, spring thaw and wet periods make compaction and clean delivery harder, so plan deliveries for dry periods when possible and expect some scheduling delays in winter or after heavy rain.

Cost-effective alternatives include crusher run (also called road base), recycled concrete aggregate, and dense-graded gravel, which all compact well and make stronger bases than loose fill-dirt. These options often cost a bit more per yard than raw fill but reduce long-term maintenance because they stabilize faster and drain better. For thin leveling over soft spots, consider structural stone topped with a wearing course rather than plain fill-dirt.

Fill-dirt can compact to form a usable subgrade, but its drainage depends on the soil mix—high clay content common in parts of West Pennsylvania drains slowly. For a durable driveway, top compacted fill with a structural aggregate such as crusher run or 3/4u0022 crushed stone and consider a wearing layer (for example #57 stone) to improve drainage and resistance to rutting. Adding geotextile and proper grading will improve long-term performance in Windsor’s freeze-thaw seasons.

Delivery costs vary by distance, truck type, and site access; local drops within a supplier’s zone are often included, while longer hauls or difficult access can add roughly $50 to $200 or more. Large tri-axle dump trucks are common for bulk orders and minimize per-ton cost, but smaller or partial loads raise the per-ton price. Mention tight driveways, overhead wires, or a need to place material in the backyard when requesting a quote because they can require smaller trucks or more labor.

Pea gravel is not recommended for driveways or places with vehicle traffic because the round stones shift and create ruts and tracking. For driveways and stable bases in Windsor, choose angular crushed stone such as crusher run, 3/4u0022 crushed stone, or #57 stone depending on whether you need base, binder, or wearing layers. Local suppliers may offer regionally sourced aggregates with different color and fines content, so request samples if appearance matters.

Include a clear drop location with address, best gate or driveway entrance, any narrow streets or low-hanging wires, and a daytime phone number so the driver can call on arrival. Note if you want the driver to consider tailgate spreading (drivers may perform this at their discretion but it is not guaranteed) and mention any access constraints or permits on site. Adding photos or a short description of access conditions speeds up quoting and helps the hauler plan the correct truck size.

Plan at least a few business days ahead: standard delivery is typically 2 or more business days, and next-day delivery is available for orders placed before noon CST for an additional fee. Because Windsor projects can be affected by weather, holidays, and regional demand, booking earlier gives you more date options and reduces the chance of delays. If you need to change an order, contact our team as soon as possible and we will do our best to accommodate you before the load is dispatched.