Fill Dirt in Lees Summit, MO

Prices for basic fill-dirt in the Lees Summit area typically vary by supplier, moisture content, and seasonal demand; expect a wide range in material-only cost and ask for a local quote. Hello Gravel requires a 3-ton minimum and uses local suppliers and tri-axle trucks; delivery is often included in many areas but may carry an extra fee for next-day service or restricted access. Check your zip code on our site or contact our team for an up-to-date per-ton estimate for your address.

To raise 1,000 sq ft by 6 inches you need about 18.5 cubic yards (500 cubic feet). Fill-dirt in this region typically weighs 1.2 to 1.6 tons per cubic yard, so plan for roughly 22 to 30 tons of material before compaction. We recommend ordering 10-20% extra to allow for settlement and compaction, so a safe order size is about 25 to 36 tons.

Because Lees Summit soils tend toward clay and the area experiences freeze-thaw cycles, use structural or engineered fill (a sand/gravel or crushed aggregate base) where stability and drainage matter. Plain high-clay fill-dirt is OK for non-structural grade raises, but under driveways or pads you should put a compacted granular base (crushed stone or sand-gravel mix) to reduce frost heave. If in doubt, ask a local contractor or soils engineer for a small test and a recommended layer build-up and compaction spec.

Hello Gravel partners with local suppliers serving Lees Summit and Jackson County and will match you with haulers in your zip code. Typical truck sizes for fill-dirt deliveries are tri-axle dump trucks, which commonly carry roughly 10 to 14 tons of soil per load depending on material moisture and local truck capacity; some end-dumps or belly-dumps carry more. Our minimum order is 3 tons, but many residential deliveries are one tri-axle load; request a quote to see exact available suppliers and truck options.

Small residential fill projects often do not require a city permit, but larger grading changes, new driveways, or work that alters drainage usually do require permits from the City of Lee's Summit or Jackson County. HOA rules and covenants in Lees Summit subdivisions vary widely and may restrict visible grading, driveway changes, or outside material deliveries. Before ordering, check with the City of Lees Summit permits office and your HOA to confirm requirements and avoid rework.

For small yard fills, a rented plate compactor or walk-behind vibratory roller usually does the job; larger projects typically need a contractor with a vibratory steel drum roller or small padfoot roller. Contractors can compact to project specs (often 90-95% Standard Proctor for structural fills), inspect lifts, and manage drainage features important in Lees Summit's climate. If you plan to use the area for a driveway, patio base, or heavy loads, we recommend hiring a professional compaction contractor.

Fill-dirt is intended to raise grades and fill voids but often contains clay so it does not drain as well as crushed rock. Crushed rock or gravel is a better base under driveways and areas needing drainage or frost resistance, while topsoil is for planting and vegetation. For many Lees Summit projects the best approach is a layered build: compacted granular base (crushed rock) for drainage and stability, capped with fill-dirt where needed, and a top layer of topsoil for planting.

A plain fill-dirt surface without a gravel or paved top will erode, rut, and settle within a season or two under vehicle traffic. If the fill is used as a base and covered with a well-compacted gravel surface or pavement, the base can last many years with regular maintenance like winter grading and occasional top-dressing every few years. Proper compaction, drainage control, and a granular surface layer greatly extend life and reduce freeze-thaw damage in Lees Summit.

Yes. Winter freezes, muddy spring conditions, and high summer landscaping demand all affect when trucks can deliver and how much suppliers charge. Frozen ground or limited access during rainy periods can cause delays or extra fees, and peak season demand can raise material prices. We recommend ordering early for spring projects and checking for next-day options and weekend windows when available.

Many local contractors and haulers in the Lees Summit area offer delivery-plus-spreading and compaction bundles, and Hello Gravel can help coordinate those services. Because spreading and proper compaction add labor and equipment, expect a premium over material-only pricing—the range is typically a modest percentage up to a higher contractor fee for turnkey installation depending on scope. Drivers may offer limited tailgate spreading at their discretion, but for guaranteed spreading and compaction you should book a contractor or request a bundled service.

Measure carefully, order 10-20% extra for settlement, and confirm truck access, overhead obstructions, and preferred drop location with the hauler before delivery. Add notes in your order about driveway approach, gate codes, or spreading requests, and verify permits or HOA rules if your project changes drainage or curb cuts. If you need help calculating quantities or bundling spreading/compaction, contact Hello Gravel for a local quote and recommendations.

As of today, we require 2 business days for delivery.

Use our material calculator here: https://hellogravel.com/calculator/ to enter the length, width and depth measurements of your project. It will automatically calculate the cubic yards/tons needed. If you are unsure how much to order, contact our team for guidance.

Please type in your zip code on any product screen and it will let you know if we service your area. The chances are that we do!

The material will be delivered via dump truck. If your order is under 20 tons, then it will likely be just one dump truck load. If your order is more than 20 tons, it will be more than one dump truck load.

Absolutely! Try our aggregate quiz here: https://hellogravel.com/aggregate-quiz/ Alternatively,you can call us, chat with us (box in the bottom right corner of the website), or email us!

We cannot get out of the truck and manually spread it. However, depending on the location, safety, and comfortability of the driver – we may be able to tailgate spread your material. This involves pulling the truck forward as material is being dumped to make it easier for you to distribute material after delivery.

The minimum order size is 3 tons.

Hassle Free! Our goal is to make the buying process for gravel and other aggregates as easy and seamless as possible. Enter your zip code on our site, select how much material you need (see below FAQ’s to determine order size), select the date and time frame you would like your material delivered at Checkout, and place your order with any major credit card. After the order is placed our in-house support team will contact you to confirm the details. We will send additional confirmations on the day before and the day of delivery. On delivery day, a dump truck will arrive to dump the materials at your specified location. We request that you have someone available to accept the delivery so that we can make sure to dump it in the correct location. That’s it!

No, because we are a national supplier, we utilize our existing network of suppliers across the country. Therefore, the materials will likely be delivered from a contracted trucking company.

We specialize in making the aggregate buying process as easy and seamless as possible by managing the process from end to end. We have a network of suppliers that we source the materials from where we have negotiated rates. However, we do charge a markup and because of this you may be able to find the materials cheaper on your own. But if you want a hassle free experience, then we are for you!

Please fill out the Quote Request form and we will work up a quote for you! https://hellogravel.com/quote-form/

Although uncommon, due to regional sourcing, the type and color of our materials may vary somewhat from the images on our website, reflecting the unique geological offerings of your area. Please communicate any specifications you desire to our team so we can consider them during the sourcing process.

Please contact our customer service team promptly if you experience any delivery or product quality issues. We will work to resolve them satisfactorily.

We are headquartered in New Orleans, LA. However, we have a network of suppliers across the country from which we provide the materials.