Gravel in Parkland, WA

Prices vary by material and supplier, but in Parkland expect roughly $30 to $75 per ton for common gravels on small orders. Crushed rock and base stone tend to be on the lower end, while decorative or washed pea gravel is toward the higher end; delivery, distance, and any required loading or access fees can raise the total. Hello Gravel has a 3-ton minimum and often offers free delivery in many areas, so check our checkout for exact local pricing and available delivery dates.

Contractors in West Washington commonly use a layered approach: a compacted 3/4u0022 minus or crushed rock base for strength and drainage, topped with 3/8u0022 to 3/4u0022 crushed gravel or pea gravel for a finished surface. Crushed angular stone locks together and resists rutting better in wet conditions, while pea gravel drains well but may migrate without good edging. Ask for locally sourced materials since regional mixes reflect local geology and performance.

For a 20x20 ft driveway (400 sq ft): 3 inches = about 3.7 cubic yards (≈ 4.8 tons), 4 inches = about 4.9 cubic yards (≈ 6.4 tons), and 6 inches = about 7.4 cubic yards (≈ 9.6 tons). These ton estimates use a typical conversion of about 1.3 tons per cubic yard; actual weight varies by material. Order 10% extra to allow for compaction, settlement, and grading waste.

Gravel drains quickly and is less expensive to install than asphalt or concrete, which helps in Parkland's rainy, mild-climate conditions. It requires more regular maintenance (regrading, replenishing, weed control) and can rut under heavy traffic unless built with a good base and edging. Asphalt and concrete are more durable and lower maintenance long term but cost significantly more up front and need proper drainage to avoid freeze/thaw or heave issues.

Supply and pricing depend on local quarries and haul distance; in Pierce County you’ll often find competitive pricing because materials are regionally sourced. Bulk price considerations include material type, delivery distance, minimum order (Hello Gravel minimum is 3 tons), and access or offload difficulty. Use Hello Gravel to compare local suppliers, get transparent quotes, and schedule delivery dates that work for your project.

In Parkland, light- to medium-use gravel surfaces typically need annual light regrading and spot maintenance, with a top-up of material every 2 to 5 years depending on traffic and drainage. Heavily used driveways or areas without proper base and edging may need more frequent attention. Good base preparation, proper slope, and edge restraints reduce how often you need to add material.

Yes. Check Pierce County or Parkland municipal rules for driveway permits, curb cuts, culvert requirements, and stormwater rules before you start. Gravel can increase runoff if not installed with proper grading, so include a stable base, drainage swales, or a culvert where needed and consider permeable design strategies. When in doubt, contact county public works or your Hello Gravel rep to confirm local requirements.

Contractors recommend installing geotextile fabric over compacted subgrade, then a 4u0022–6u0022 compacted layer of 3/4u0022 minus crushed rock as a load-bearing base, finished with a 1u0022–2u0022 layer of smaller crushed gravel or pea gravel. Use solid edge restraints—timber, concrete curbing, pavers, or metal edging—to keep material contained and reduce migration. Proper compaction with a plate compactor and gentle slopes for drainage are also essential to prevent washout.

Gravel weights vary by type, but a simple rule is 1 cubic yard ≈ 1.2 to 1.5 short tons. A typical conversion many contractors use is about 1.3 tons per cubic yard for common crushed stone and gravel; pea gravel and river rock can be a bit heavier. When ordering, state the material type and ask your supplier or Hello Gravel estimator for the exact conversion for that product.

Many Parkland contractors provide full installation services including grading, base prep, compaction, and edging; availability depends on the contractor and schedule. Labor costs vary with scope: small driveway installs often range from several hundred to a few thousand dollars, while hourly rates for crews commonly fall in the $50 to $100 per hour range depending on crew size and local demand. Get written quotes that break out materials, delivery, and labor so you can compare accurately.