Gravel in Fort Caroline Shores, FL

A tri-axle dump truck typically delivers about 10 to 12 tons of loose gravel. Material prices in Florida commonly range from about $25 to $60 per ton depending on type (pea, crushed stone, shell, etc.), so a delivered load often runs roughly $300 to $900 including delivery and fees. Hello Gravel requires a 3-ton minimum and can give an exact quote for your zip code and delivery options.

Prices depend on the type: common crushed stone or base material is usually $25 to $45 per ton, decorative shell or river rock runs higher. Local factors like availability, truck access, and delivery distance affect the final price, so we recommend getting a zip-code specific quote through Hello Gravel for an accurate cost.

Common sizes include 3/8u0022 (fine), 1/2u0022 and 3/4u0022 crushed stone, #57 (about 3/4u0022), and larger 1u0022–2u0022 rock used for drainage or decoration. Fine mixes and crusher-run contain fines and compact well for driveways and paths, while rounder pea gravel and river rock are decorative and drain well. Ask your supplier for samples since appearance and sizing vary by local source.

Yes — suppliers near Fort Caroline Shores typically stock crushed limestone, crushed shell or coquina, river rock, and various sized crushed stone. Because Hello Gravel sources regionally, the exact texture and color will reflect local geology, so you can request photos or a sample when you place an order.

A 20 ft long driveway estimate depends on width and depth. For a single-car driveway 20 ft long by 10 ft wide at 3u0022 depth, you need about 2 cubic yards (roughly 3 tons), so material alone may be about $75 to $180; add delivery and any spreading/labor, and total installed cost typically ranges from $200 to $600. For heavy traffic or poor soils in coastal Florida, plan for a thicker compacted base which increases material and labor costs.

Twenty tons is roughly 14 to 15 cubic yards (use 1 cubic yard ≈ 1.4 tons as a rule of thumb). That will cover about 1,540 sq ft at a 3u0022 depth or about 1,160 sq ft at a 4u0022 depth. Actual coverage varies with material density and compaction, so order a little extra when planning.

Buying in bulk (by the ton or by the truckload) generally gives the lowest per-ton price, and consolidating delivery minimizes hauling fees. Using local, regional materials like crushed limestone or screenings also cuts cost, and Hello Gravel can show nearby supplier options so you can compare material and delivery rates for the best deal.

Labor rates vary by scope: basic spreading and raking by local crews often runs between $40 and $90 per hour, depending on crew size and travel. $100 per hour may be on the high side for simple spreading in Fort Caroline Shores, but it can be reasonable for skilled equipment operators, complicated grading, or small crews with high demand — always get written estimates from several contractors.

One cubic yard covers about 324 sq ft at a 1u0022 depth. That translates to roughly 108 sq ft at 3u0022 depth, 81 sq ft at 4u0022 depth, and 162 sq ft at 2u0022 depth. One cubic yard weighs about 1.2 to 1.6 tons depending on the material; use 1.4 tons as a practical estimate when converting.

Gravel alone will not become concrete, but certain compactable mixes (like crusher-run or well-graded base with fines) can form a very hard, stable surface when properly installed and compacted. For a truly rigid surface you need paving or a stabilizer (polymer binders or cement-treated base), and in wet, coastal Florida soils it's important to design for drainage and compaction rather than relying on gravel alone to behave like concrete.

Two inches of loose gravel is generally too thin for driveways, especially with vehicle traffic and Florida's heavy rain; it may work for temporary walkways over a well-prepared base. For driveways, plan on a compacted base layer of 4 to 6 inches of aggregate plus a 2 to 3 inch surface layer for lasting performance, and consider local drainage and high water table when setting depth.

Size names like '#3' vary by supplier, but #3 commonly refers to a mix of stones roughly 1/2u0022 to 2u0022 in size used for drainage, French drains, and backfill. It tends to be chunkier than #57 and works well where coarse drainage is needed. Always ask your supplier for a sample photo because local suppliers use slightly different naming conventions.

A common local approach is a compactable base (crusher run or road base) topped with #57 crushed stone or crushed limestone for traction and drainage. In coastal areas you may see crushed shell for aesthetic reasons, but shell is less durable under heavy traffic. Prioritize a stabilized, compacted base and good drainage to handle Florida's storms and wet soils.

At 3u0022 depth, 1,000 sq ft needs about 9.3 cubic yards (roughly 13 tons). With material prices of $25 to $60 per ton, material-only costs typically fall between about $325 and $780, plus delivery and any spreading or compaction charges. For an accurate total get a Hello Gravel quote for your address and desired material type.