Gravel in Marysville, WA

Typical retail prices in the Marysville area vary by type: washed pea gravel or river rock often runs higher, roughly $50 to $90 per ton, while common crushed base or crushed rock generally falls around $35 to $65 per ton. A rough conversion is 1 cubic yard ≈ 1.4 tons, so expect per-cubic-yard prices about 1.3 to 1.5 times the per-ton price. Final price depends on supplier, delivery distance, and whether you order washed or specialty color gravel.

Hello Gravel works with trusted suppliers and haulers across Snohomish County and will show available local suppliers and delivery fees during checkout for your zip code. Delivery fees in the Marysville area commonly range from free up to about $100-$150 depending on order size and distance, though exact fees depend on the supplier and truck routing. Contact our team or check your quote in checkout for supplier names and the precise delivery charge.

In Marysville's wet, rainy climate, angular crushed rock (3/4u0022 crushed rock or crushed fines for the base) compacts well and resists tracking better than smooth river rock or pea gravel. For drainage layers use clean, washed 1u0022 to 1-1/2u0022 drainage rock or perforated drain rock, and reserve pea gravel or river rock for decorative areas or dry creek beds rather than primary driveway surfaces. Combining a compacted crushed base, geotextile fabric, and a wearing surface of crushed stone gives the most durable, low-maintenance result in wet conditions.

For 100 sq ft: 2u0022 depth = about 0.62 cubic yards ≈ 0.9 tons; 3u0022 depth = about 0.93 cubic yards ≈ 1.3 tons; 4u0022 depth = about 1.23 cubic yards ≈ 1.7 tons. These estimates use 1 cubic yard ≈ 1.4 tons and are typical for crushed stone; local material density may vary. Remember Hello Gravel minimum orders start at 3 tons, so a small 100 sq ft area will usually require ordering the minimum amount.

Material-only costs depend on type (see price ranges above), but contracting for a basic gravel driveway install including base prep, geotextile, and compaction often ranges roughly $2 to $6 per sq ft for straightforward jobs. More complex sites with excavation, drainage work, or steep grades can run $6 to $12 per sq ft. Contractors may also price by the ton or cubic yard; expect installation labor and base materials to add roughly $10 to $30 per ton on top of material cost, depending on site conditions.

Permit and HOA rules vary: Marysville may require permits for new driveway curb cuts, changes to impervious surface, or significant grading work, and many HOAs have rules about front-yard treatments and allowed materials. Before ordering, check the City of Marysville building and public works departments and review any HOA design guidelines. When in doubt, contact Hello Gravel or your local planning office to confirm requirements for your specific address.

For slopes, start with good base preparation: excavate to the desired depth, install geotextile fabric, place and compact a 4u0022 to 6u0022 layer of crushed base rock, and then a wearing layer of 3/4u0022 crushed stone. Use sturdy edge restraints (steel, timber, or concrete) and create grade breaks or check steps to interrupt water flow; install swales, perforated underdrains, or rock-lined outlets to carry water away from the surface. For steep runs, consider terracing with retaining walls or riprap at the toe to reduce velocity and prevent washout.

With proper base and drainage, a crushed gravel driveway in the Snohomish County climate can perform well for 10 to 20 years, though some wearing surface refreshes are normally required. Plan on light maintenance annually (raking, filling low spots, fixing rutting) and topping up stone every 3 to 5 years depending on traffic and weather. Expect DIY annual maintenance costs to be modest (materials and a few hours of labor), while hiring contractors for periodic regrading or adding new stone will increase costs.

Many suppliers and local contractors in the Marysville area can supply geotextile fabric and base rock and some offer installation or compacting as an add-on service. Adding fabric and a compacted base increases upfront cost but greatly improves longevity and performance; fabric and installed base can add several hundred to a few thousand dollars depending on area size. When you request a quote through Hello Gravel, ask for line-item pricing for fabric, base rock, compaction, and installation so you can compare DIY vs contractor options.

Yes—late spring through early fall is usually best for delivery and installation in Marysville because drier weather improves compaction and reduces delivery delays. Winter and heavy rainy months can cause scheduling delays, muddy conditions, and poorer compaction, so expect potential hold-ups and extra site preparation if you build in the wet season. Suppliers also have heavier demand in warmer months, so plan ahead for larger jobs to secure timely delivery.

Drivers may be able to perform tailgate spreading at their discretion; you can request spreading at checkout, but it is not guaranteed and will be assessed for safety on arrival. For consistent results, consider hiring a contractor for spreading and compaction after delivery, or plan to rent a plate compactor and do the spreading yourself if the driver cannot provide the service.