Gravel in Valley Ranch, TX

Delivered retail prices vary by supplier and material, but expect typical ranges in Valley Ranch: crusher run/road base $30-$50 per ton ($42-$70 per cubic yard), #57 washed gravel $35-$70 per ton ($49-$98 per cubic yard), and decomposed granite $40-$80 per ton ($56-$112 per cubic yard). Hello Gravel works with local suppliers and generally requires a 3-ton minimum; many orders include free delivery, but local delivery fees can run $75-$250 for longer hauls or full truckloads. Prices fluctuate with regional supply and season, so use our calculator or request a quote for an exact delivered price.

Costs depend on length, required depth, and site prep. For a 20-foot-wide driveway, per 100 linear feet (2,000 sq ft) expect a ballpark installed price of $2,000-$6,000: lower end for minimal prep and basic crusher run, higher end for heavier base, engineered base, drainage work, and contractor compaction. Material-only costs for that area are roughly $700-$3,000 depending on depth and material choice; add contractor fees for grading/compaction which typically run $0.75-$3.00 per sq ft in the Valley Ranch area.

For durability in Valley Ranch's climate and local soils, crusher run (road base) is the most common choice for a compactable base because its mix of fines and angular stone locks together. For a wearing surface, #57 crushed limestone or crushed granite are popular for load-bearing and drainage; decomposed granite is attractive but best for low-traffic or decorative driveways. Local suppliers in Texas typically stock these materials, but regional color and fines content vary, so request sample photos or notes when ordering.

Properly installed and compacted crusher run will compact into a firm, load-bearing surface and performs well in much of Valley Ranch, but it depends on subgrade preparation and drainage. Unlike concrete, gravel is less expensive upfront and easier to repair, but it requires periodic maintenance (regrading and topping) and is not as long-lasting or smooth. If you need a permanent, low-maintenance surface with no regular topping, concrete will outperform gravel, but gravel is often the cost-effective choice for driveways when drainage and maintenance are acceptable.

As a rule of thumb, 1 cubic yard of gravel covers about 100 sq ft at 3 inches depth. For 100 sq ft: 2u0022 = 0.62 cu yd (about 0.9 tons), 3u0022 = 0.93 cu yd (about 1.3 tons), 4u0022 = 1.23 cu yd (about 1.7 tons), 6u0022 = 1.85 cu yd (about 2.6 tons). For a 20-foot-wide driveway per 100 linear feet (2,000 sq ft): 2u0022 = ~17 tons, 3u0022 = ~26 tons, 4u0022 = ~34 tons, 6u0022 = ~52 tons (use Hello Gravel’s calculator or contact us for a precise estimate based on your chosen material and local densities).

In Valley Ranch we recommend removing organic topsoil, grading to positive drainage, installing a geotextile fabric where needed, and laying 4u0022-6u0022 of compacted road base (6u0022-8u0022 for heavier loads) before a 1-3u0022 gravel wearing course. Typical contractor prices for site prep, base installation, and compaction run roughly $0.75-$3.00 per sq ft locally, depending on access, existing subgrade, and scope of drainage work. Always ask contractors if their price includes compaction and refuse to skip proper compaction—poor prep is the most common cause of failure in our region.

Gravel driveways generally drain well if they are built on a drained, graded subgrade; road base’s fines improve compaction but also require proper slope and base thickness so water runs off rather than pooling. In Valley Ranch, where heavy thunderstorms are common, add positive crown, side swales, or culverts at low points to carry water away from the driveway and avoid saturation. If your yard has poor natural drainage or clay subsoil, expect to pay extra for drainage improvements to keep the gravel functional year-round.

Yes, sand and gravel are priced differently: sand is typically cheaper per ton than crushed stone, often used for grading and bedding rather than as a driveway surface. For driveways, choose crushed stone or crusher run for the base and coarse gravel for the surface because sand compacts poorly and will rut under traffic. Use sand only for specific underlayment or bedding tasks (pavers, leveling), and buy it separately from your driveway stone.

Plan on light maintenance each year—raking or regrading low spots, topping up surface stone every 2-3 years, and addressing weeds and dust as needed. Small driveways may only need a few hundred dollars of material/top-up over several years; professional regrading or fresh topcoat for larger driveways can run $200-$1,000 depending on size and material. Consider periodic dust control (calcium chloride or stabilizers) and keep drainage clear to minimize larger repairs.

Mixing fines into crusher run or using basic stabilizers can improve firmness and dust control, but it is not equivalent to engineered stabilization or poured concrete. Polymer stabilizers and proper binders can work well in Valley Ranch for lower-traffic drives but add material cost and usually require professional application for best results. If you want a semi-permanent, low-maintenance surface, get quotes for polymer-stabilized gravel or engineered products from local suppliers and compare to concrete on a lifecycle-cost basis.

Use our website to select the gravel type, enter your Valley Ranch zip code, and get a delivered price and recommended quantity; Hello Gravel requires a 3-ton minimum. Standard delivery is 2+ business days with next-day delivery available for orders placed before noon CST for an additional fee; tailgate spreading is available at the driver's discretion and you can request it at checkout. If you need help calculating quantities or choosing materials for Valley Ranch soils and climate, contact our team by phone or text for guidance and a custom quote.