Fill-dirt in Morrison, TN

Delivered fill-dirt prices in West Tennessee commonly range from about $8 to $20 per ton (roughly $6 to $15 per cubic yard), depending on supplier, distance, moisture content, and local demand. Your final price will be shown at checkout after entering your zip code; Hello Gravel lists local supplier pricing and notes any delivery fees or minimums.

A 10 x 20 area raised 6 inches is about 3.7 cubic yards, which is roughly 4.5 tons of fill-dirt (using 1.2 tons per cubic yard as a rule of thumb). Order 10-15% extra to allow for compaction and grading, so plan to buy about 5 to 5.5 tons; Hello Gravel’s minimum order is 3 tons and our material calculator can give an exact estimate for your address.

Fill-dirt is fine for raising grade or filling low spots, but it is not an ideal wear surface in Morrison’s clay-rich, wet conditions because it can compact poorly and rut. For a long-lasting driveway, contractors typically use fill-dirt to build the subgrade and then place a structural layer such as road base or crushed stone on top, plus geotextile fabric where drainage is a concern.

For structural backfill where compaction and load-bearing are critical, road base or engineered fill is generally preferred because it compacts reliably and sheds water better than generic fill-dirt. Fill-dirt can be used for non-structural backfill, but local building codes often require specific materials and compaction testing for footings and septic systems, so check with local inspectors and your contractor.

If used as a surface, fill-dirt typically needs maintenance or replenishment within months to a few years in Morrison due to rain-driven erosion and rutting. If used beneath a proper gravel or crushed-stone surface and compacted correctly, it can remain stable long-term with minimal replenishment needed.

Next-day delivery is often available for orders placed before noon CST for an additional fee; same-day delivery may be possible in some cases but is not guaranteed and depends on supplier and truck availability. Hello Gravel’s minimum order is 3 tons, deliveries are by contracted dump trucks (typically tri-axle), and delivery fees vary by location—enter your zip code at checkout to see options and pricing.

Fill-dirt can be used to regrade slopes, but it is not an erosion-control solution by itself because it lacks vegetation-friendly soil and is prone to washout on steep, rain-prone slopes. For erosion control in Morrison, use fill-dirt for shaping, then add topsoil and vegetation, erosion-control blankets, or riprap where concentrated flow or steep slopes require hard protection.

Fill-dirt is cheaper for building up grade but is not durable as a surface for parking; crushed stone or compacted aggregate bases are more durable and cost-effective over time for parking pads in Morrison’s wet climate. A common approach is to use fill-dirt to reach grade, then install 3 to 6 inches of crushed stone or compacted road base as the wearing surface.

You may need permits for large grading, filling, or changes to drainage depending on Warren County and Morrison town rules, especially if work affects wetlands, streams, or neighboring properties. Check with the Morrison town office or Warren County building/permits department before large projects, and ask local suppliers or contractors for guidance on typical permit requirements.

Contractors commonly place fill-dirt in 4- to 8-inch lifts, compact each lift with a plate compactor or roller to specified density, and keep moisture content near optimum for compaction. They also shape the site for positive drainage, use geotextile fabric where soft subgrade exists, and allow for 5-10% extra material to account for settlement and grading.