Fill-dirt in Bellevue, TN

In Bellevue (West Tennessee) fill-dirt prices typically range from about $8 to $25 per cubic yard or $6 to $18 per ton, depending on local supply, moisture, and delivery. A typical tri-axle dump truck (10-12 cubic yards) will often cost in the $80 to $300 range delivered, but minimum orders and access issues can raise that price. Check your zip code for exact rates and remember Hello Gravel has a 3-ton minimum and can provide a local quote.

Yes — fill dirt is generally cheaper than gravel because it is less processed and often sourced from excavation material. In West Tennessee you will usually pay noticeably less for fill dirt than for crushed stone or decorative gravel, but prices vary by supplier and dump distance.

Fill dirt is mostly subsoil — clay, silt, sand, and small organics — used to raise or level ground and provide a working substrate. Gravel is crushed rock or rounded stone used for drainage and surfaces; it does not compact like fill dirt and serves different structural and finish purposes.

You can, but it is not recommended to place pea gravel directly onto loose fill dirt. In West Tennessee you should compact the fill dirt and add a crushed-stone base (and ideally a geotextile) to prevent the pea gravel from sinking and mixing with the underlying soil.

A dump-truck load of fill dirt in West Tennessee typically ranges from about $100 to $350 delivered for a standard tri-axle load, depending on distance, site access, and moisture content. Heavy wet dirt and tight access can increase hauling and dumping fees, so request a site-specific quote from Hello Gravel for the most accurate price.

No — 2 inches of fill dirt is not sufficient as a driveway base. For a stable driveway you should plan for several inches of compacted structural fill and 3 to 6 inches of compacted crushed stone on top; the exact depths depend on soil conditions in Bellevue and anticipated vehicle loads.

To estimate cubic yards, use: cubic yards = (square feet x depth in inches) / 324. For example, 1,000 sq ft at 2 inches depth is about 6.2 cubic yards; at 6 inches it is about 18.5 cubic yards. Always add 5% to 15% for compaction and settling, and ask Hello Gravel for a precise estimate based on your job.

One cubic yard of fill dirt is a 3-foot by 3-foot by 3-foot pile and typically fills a full-size wheelbarrow about 12 to 15 times. In practical terms, one cubic yard will cover roughly 100 sq ft at 1 inch depth or about 27 sq ft at 3 inches depth.

Prices in Bellevue usually range from about $6 to $18 per ton for basic fill dirt, depending on local availability and delivery distance. Weight can vary with moisture and composition, so Hello Gravel quotes by volume and weight may differ — request a local quote for an exact price.

It depends on width and desired depth. For example, a 20 ft long by 10 ft wide area at 4 inches deep needs: (20 x 10 x 4) / 324 ≈ 2.47 cubic yards, so plan on about 2.5 to 3 cubic yards plus extra for compaction. For structural driveway work you may need additional crushed stone and deeper fill, so get a site-specific recommendation.

Yes — fill dirt should be compacted in layers to reduce settling, especially in West Tennessee where clay and silty soils can change volume with moisture. Use mechanical compaction (plate compactor or roller) in 4 to 8 inch lifts and test compaction where structural support is needed.

Under gravel on fill dirt, compact the fill dirt first, then add a geotextile fabric if drainage or separation is needed, followed by a compacted base of crushed stone (typically 3 to 6 inches). Proper grading and drainage are important in Bellevue to prevent washout and mixing of the gravel with the underlying soil; consider professional advice for driveways and load-bearing areas.