Fill Dirt in Valle Crucis, NC

Delivered fill dirt prices in Valle Crucis vary by supplier, haul distance, and whether the material is screened or 'clean' fill. Expect a rough ballpark of about $10 to $25 per cubic yard (approximately $8 to $19 per ton) depending on local avaIlability and trucking; exact pricing requires a quote. Hello Gravel requires a 3-ton minimum and will show delivery fees or free-delivery options for your zip code at checkout.

Hello Gravel connects you with trusted local suppliers and haulers that serve Valle Crucis rather than naming a single quarry. Typical minimum orders Start at 3 tons; some suppliers or small haulers may have higher minimums for short runs or constrained access. Delivery fees depend on distance and site conditions—many areas have free delivery while steep or remote sites can incur surcharges—so request a quote and add site access notes at checkout.

Fill dirt is best used to raise grade or fill low spots, but it is not an ideal structural base for driveways; for driveways and building pads use a well-graded, low-fines granular base (ABC or crushed stone) over compacted, non-organic fill. If you must place structural fill, use clean, non-organic, well-graded material placed in 6- to 8-inch lifts and compacted to typical engineering targets (often 90–95% standard proctor); consult a geotechnical engineer for freeze-thaw and slope-sensitive work in the mountains.

Hilly and rocky terrain increases required fill because you often need benching, berming, or retaining structures; expect volume estimates to rise by 10–30% compared with flat sites due to cut-and-fill inefficiencies. Rocky ground may require additional excavation or specialized fill to create a workable surface, and slopes need erosion-control measures like geotextile, seeding, or riprap to keep fill in place after delivery.

Permitting depends on the scope of work: small landscape fills usually need no special permit, but disturbing significant area (commonly 1 acre or more), altering drainage, or changing septic/drain fields can trigger Watauga County or North Carolina permits and sediment-and-erosion rules. Check with Watauga County Planning and the North Carolina Department of Environmental Quality before large deliveries, and obtain driveway or grading permits if required.

Delivery cost rises with haul distance because trucking time and fuel increase; many suppliers charge a base rate for a local radius and add a mileage surcharge beyond that. Exact per-ton or per-mile charges vary by supplier and current fuel costs, so get a site-specific quote—Hello Gravel will show delivery surcharges in your checkout for the exact address.

To raise 1 acre by 6 inches requires about 806 cubic yards, which converts to roughly 960 to 1,210 tons depending on material density (use about 1.2–1.5 tons per cubic yard as a guide). A 12-foot by 200-foot area at 6 inches deep is about 44 cubic yards, or roughly 53 to 66 tons using the same density range; always add 5–15% to cover settlement and grading losses.

Fill dirt surfaces are prone to settling, wAshouts, and erosion in freeze-thaw and heavy-rain conditions common in the area, so expect to regrade and add material periodically. For access roads or driveways, top-up or regrading every 1–3 years is common unless you cover the surface with pRoper gravel, paving, or erosion-control measures.

Fill dirt is useful for raising elevation and backfill but performs poorly as a driving surface or drainage layer because it compacts and can hold water. Crushed stone or ABC is superior for driveway bases and septic field cover where drainage and structural support are required; for erosion control, combine fill with vegetation, mulch, geotextile, or rock to stabilize slopes.

Many local excavators, landscapers, and sitework contractors in the West North Carolina area offer spreading, compaction, and grading—Hello Gravel can connect you to suppliers but not list specific contractors. Typical equipment rates in the region are roughly $100–$200 per hour for an excavator or loader with operator, and smaller crews often bill $50–$90 per hour per laborer; final rates depend on job complexity and scheduling, so get local estimates.

Hello Gravel coordinates deliveries via local dump truck fleets, usually tri-axle trucks; drivers will assess site access and may decline unsafe offloads. For narrow drives, steep grades, or locations requiring smaller trucks or spotters, note the constraints in Order Notes and send photos—additional fees or alternate hauling arrangements may be needed.

For structural work request clean, non-organic fill free of roots, vegetation, and debris; specify low organic content and a well-graded material suitable for compaction. For foundations or load-bearing pads, use engineered structural fill with compaction testing per an engineer's recommendations rather than generic landscape fill.

As of today, we require 2 business days for delivery.

Use our material calculator here: https://hellogravel.com/calculator/ to enter the length, width and depth measurements of your project. It will automatically calculate the cubic yards/tons needed. If you are unsure how much to order, contact our team for guidance.

Please type in your zip code on any product screen and it will let you know if we service your area. The chances are that we do!

The material will be delivered via dump truck. If your order is under 20 tons, then it will likely be just one dump truck load. If your order is more than 20 tons, it will be more than one dump truck load.

Absolutely! Try our aggregate quiz here: https://hellogravel.com/aggregate-quiz/ Alternatively,you can call us, chat with us (box in the bottom right corner of the website), or email us!

We cannot get out of the truck and manually spread it. However, depending on the location, safety, and comfortability of the driver – we may be able to tailgate spread your material. This involves pulling the truck forward as material is being dumped to make it easier for you to distribute material after delivery.

The minimum order size is 3 tons.

Hassle Free! Our goal is to make the buying process for gravel and other aggregates as easy and seamless as possible. Enter your zip code on our site, select how much material you need (see below FAQ’s to determine order size), select the date and time frame you would like your material delivered at Checkout, and place your order with any major credit card. After the order is placed our in-house support team will contact you to confirm the details. We will send additional confirmations on the day before and the day of delivery. On delivery day, a dump truck will arrive to dump the materials at your specified location. We request that you have someone available to accept the delivery so that we can make sure to dump it in the correct location. That’s it!

No, because we are a national supplier, we utilize our existing network of suppliers across the country. Therefore, the materials will likely be delivered from a contracted trucking company.

We specialize in making the aggregate buying process as easy and seamless as possible by managing the process from end to end. We have a network of suppliers that we source the materials from where we have negotiated rates. However, we do charge a markup and because of this you may be able to find the materials cheaper on your own. But if you want a hassle free experience, then we are for you!

Please fill out the Quote Request form and we will work up a quote for you! https://hellogravel.com/quote-form/

Although uncommon, due to regional sourcing, the type and color of our materials may vary somewhat from the images on our website, reflecting the unique geological offerings of your area. Please communicate any specifications you desire to our team so we can consider them during the sourcing process.

Please contact our customer service team promptly if you experience any delivery or product quality issues. We will work to resolve them satisfactorily.

We are headquartered in New Orleans, LA. However, we have a network of suppliers across the country from which we provide the materials.