Fill Dirt in Merritt, NC

Fill dirt is native or quarried soil used to raise or level ground and fill holes; it usually has minimal organic matter and larger mineral content. In Merritt, homeowners use it for building up yard grades, preparing sites for patios or sheds, and under driveways before a gravel or road base layer is installed. Because West North Carolina has hilly terrain, contractors often use well-compacted fill dirt to reduce settling on slopes and create a stable subgrade.

Delivered prices in Merritt typically vary by supplier, distance, and quantity, but expect roughly $12 to $30 per ton and about $15 to $40 per cubic yard as a general range. Larger orders usually lower the per-ton price and additional fees can apply for tight access, on-site spreading, or next-day delivery. For an exact price, check your zip code on Hello Gravel and get a local quote.

For clay-prone sites in West NC, a well-graded granular fill (a mix with fewer fines and some sand or small rock) helps improve drainage compared with pure clay fill. Contractors often place a layer of granular fill or crushed stone beneath topsoil, and then compact in lifts to encourage water to move through rather than pond. If drainage is a major concern, ask suppliers for “clean” or “granular” fill and consider an engineered base layer or perforated drainage pipe.

Contractors typically place fill dirt in 6- to 12-inch lifts and compact each lift to about 90% to 95% of the Standard Proctor maximum dry density, depending on project specs. For driveway subgrades, getting close to 95% is common to reduce future settling and rutting. Always verify any required compaction level with your local builder or county inspector before final grading.

Small deliveries for private yard work usually do not require permits, but large-volume imports, work in regulated floodplains, or projects that change drainage patterns may need county or city permits. West North Carolina also has sTate rules on erosion and sedimentation for larger earthmoving projects, so check with your county planning or soil and water office before ordering big loads. When in doubt, contact Hello Gravel for help and confirm local permitting requirements.

A 20 x 30 ft area at 6 inches deep equals 300 cubic feet, which is about 11.1 cubic yards. Fill dirt typically weighs about 1.2 to 1.4 tons per cubic yard depending on moisture and compaction, so you would need roughly 13 to 16 tons for that job. Order a little extra (5% to 10%) to allow for compaction and uneven grading.

Hello Gravel’s minimum order is 3 tons, so very small loads under that amount are generally not avaIlable through our standard service. Same-day delivery can sometimes be arranged depending on local supplier and truck avaIlability, but standard delivery is 2+ business days and next-day is avaIlable for orders placed before noon CST for eligible areas. Check checkout options for your zip code or call our team to ask about expedited or special arrangements.

Clean fill dirt (minimal organics and debris) usually costs more than recycled or controlled-fill because it is screened and has more predictable performance; expect a premium of roughly $3 to $12 per ton depending on local supply. Recycled or controlled fill can be cheaper but may contain more fines, organics, or recycled material that affect settlement and drainage. Choose clean fill for structural areas or under driveways, and consider a lower-cost recycled option for non-structural garden fills after confirming suitability.

When pRoperly placed, compacted, and capped with road base or crushed stone, fill dirt can provide a stable subgrade for many years, but settlement can occur if lifts are not compacted or if drainage is poor. Inspect your driveway annually after heavy rains and after winter freeze-thaw cycles; regrade low spots, add more base rock if ruts appear, and keep surface drainage away from the subgrade. Good initial compaction and drainage are the best ways to minimize maintenance in Merritt’s climate.

For slopes, use a well-graded, granular fill with some sand and small rock and place it in compacted lifts to reduce erosion and settling. Combine the fill with erosion-control measures—such as geotextile fabric, terraces, retaining walls, and vegetation—to slow water flow and protect the slope. On steeper slopes or where wAshout risk is high, consult a local contractor or engineer to specify engineered fill and drainage solutions.

Fill dirt is intended as subgrade material to raise or level ground but is not a durable surfacing material for driveways. For a lasting driveway in Merritt, use compacted fill dirt to build the subgrade, then add a layer of road base or crushed stone on top for structural support and a wearing surface. Road base and crushed stone provide better drainage and load distribution, so combine them with pRoperly compacted fill for best results.

As of today, we require 2 business days for delivery.

Use our material calculator here: https://hellogravel.com/calculator/ to enter the length, width and depth measurements of your project. It will automatically calculate the cubic yards/tons needed. If you are unsure how much to order, contact our team for guidance.

Please type in your zip code on any product screen and it will let you know if we service your area. The chances are that we do!

The material will be delivered via dump truck. If your order is under 20 tons, then it will likely be just one dump truck load. If your order is more than 20 tons, it will be more than one dump truck load.

Absolutely! Try our aggregate quiz here: https://hellogravel.com/aggregate-quiz/ Alternatively,you can call us, chat with us (box in the bottom right corner of the website), or email us!

We cannot get out of the truck and manually spread it. However, depending on the location, safety, and comfortability of the driver – we may be able to tailgate spread your material. This involves pulling the truck forward as material is being dumped to make it easier for you to distribute material after delivery.

The minimum order size is 3 tons.

Hassle Free! Our goal is to make the buying process for gravel and other aggregates as easy and seamless as possible. Enter your zip code on our site, select how much material you need (see below FAQ’s to determine order size), select the date and time frame you would like your material delivered at Checkout, and place your order with any major credit card. After the order is placed our in-house support team will contact you to confirm the details. We will send additional confirmations on the day before and the day of delivery. On delivery day, a dump truck will arrive to dump the materials at your specified location. We request that you have someone available to accept the delivery so that we can make sure to dump it in the correct location. That’s it!

No, because we are a national supplier, we utilize our existing network of suppliers across the country. Therefore, the materials will likely be delivered from a contracted trucking company.

We specialize in making the aggregate buying process as easy and seamless as possible by managing the process from end to end. We have a network of suppliers that we source the materials from where we have negotiated rates. However, we do charge a markup and because of this you may be able to find the materials cheaper on your own. But if you want a hassle free experience, then we are for you!

Please fill out the Quote Request form and we will work up a quote for you! https://hellogravel.com/quote-form/

Although uncommon, due to regional sourcing, the type and color of our materials may vary somewhat from the images on our website, reflecting the unique geological offerings of your area. Please communicate any specifications you desire to our team so we can consider them during the sourcing process.

Please contact our customer service team promptly if you experience any delivery or product quality issues. We will work to resolve them satisfactorily.

We are headquartered in New Orleans, LA. However, we have a network of suppliers across the country from which we provide the materials.