Fill Dirt in Benjamin, UT

Delivered fill-dirt prices in Benjamin commonly range from about $10 to $30 per ton, depending on haul distance, truck access, moisture content, and minimum order size. Local sourcing and seasonal demand can push prices higher, so check your zip code on Hello Gravel or request a quote for an exact delivered price.

Fill-dirt sold around Benjamin is usually fine-grained soil made mostly of sand, silt, and small clay particles with occasional small gravel; it is not graded like engineered base materials. Because it contains a lot of fines, it holds water and compacts poorly for structural bases, so it is best for raising grade and general backfill rather than as a driveway base.

Benjamin's high-desert climate has cold winters and some freeze-thaw activity, which can cause fine-grained fill-dirt to heave or settle if it retains moisture. To reduce movement, compact fill in thin lifts, provide good surface drainage, and cap the fill with a granular layer (crushed rock) before paving or traffic.

Fill-dirt is not recommended as the structural layer for driveways; use engineered road base or crusher-run for load-bearing applications. If fill-dirt must be placed beneath non-structural areas, place in 4 to 8 inch lifts and compact each lift to a contractor target of about 90-95% of Standard Proctor; consult a geotechnical or local contractor for driveway subgrade approval.

A rule of thumb for fill-dirt is about 1.2 to 1.6 tons per cubic yard depending on moisture; use 1.4 tons/yd3 for quick estimates. For example, to raise 1,000 sq ft by 6 inches you need about 18.5 cubic yards, or roughly 26 tons of fill-dirt; a 500 sq ft area at the same depth needs about 13 tons.

Use fill-dirt when you need to raise grade or fill non-structural areas where drainage and settlement are not critical. For driveways and load-bearing surfaces in Benjamin, choose crusher-run or engineered road base because those materials compact well, shed water, and support traffic; they are the correct choice for long-lasting driveways and parking areas.

Hello Gravel connects you with local suppliers and contracted haulers who source materials regionally for the Benjamin area. Typical lead times are our standard 2+ business days, with next-day delivery available for orders placed before noon CST for an extra fee; exact timing depends on supplier stock and truck availability in your zip code.

Fill-dirt used for landscape grading or yard fill will often settle over the first 1 to 3 years and may need top-up or regrading, especially after heavy rain. When used improperly under driveways it can lead to depressions and pavement failure, so plan for regular checks, good drainage, and a proper crushed-rock cap where vehicle traffic occurs.

Yes; grading work, retaining walls, or changes to lot elevations in Benjamin (Utah County) can trigger building permits or inspections, and some HOAs restrict visible surface materials or require approval for grading. Contact the Utah County Building Division and your HOA before major placement to confirm permit and design requirements.

On slopes in Benjamin, bench the fill into the slope, compact in lifts, and direct runoff into swales or rock-lined channels to avoid concentrated flow over the fill surface. Use geotextile fabric, erosion-control matting, rock riprap at outlets, and vegetation or shrubs once stabilized to minimize erosion and keep fill in place.

Measure the area and determine desired final elevations before ordering, and clear the drop zone of vehicles, fences, and utilities; mark the desired dump spot with flags so drivers can place material safely. Remember Hello Gravel minimums (3 tons) and that deliveries come by tri-axle dump truck, so ensure adequate access and mention any spreading requests in your order notes.