Fill Dirt in Mountain Green, UT

Fill dirt is mostly fine-grained soil with few rocks, used to raise or level ground. Gravel is crushed stone used for drainage and structural bases. In Mountain Green, contractors use locally sourced fill dirt to build grades and backfill, while gravel is chosen for driveways and drainage projects.

Clear the dump area of vehicles, low branches, and obstacles and mark the desired drop point with flags or stakes. Make sure a truck can access the site and note overhead wires or narrow gates; notify us of steep or soft driveways since drivers deliver by tri-axle dump and may refuse unsafe spots. If you need a permit for grading in Mountain Green, get it before delivery to avoid delays.

Standard delivery is scheduled for 2+ business days after ordering; next-day delivery may be available if you order before noon CST for an extra fee. Local factors in West Utah like road conditions, permits, and weather (heavy rain or freeze-thaw) can change timing, so check the delivery window in your order confirmation.

Yes, fill dirt typically costs less per ton than crushed gravel because it is less processed. Prices in West Utah vary by supplier and haul distance, so the exact savings depend on local availability and truck fees. For an accurate price, request a quote through Hello Gravel for Mountain Green delivery.

Calculate volume by multiplying length, width, and depth. For example, raising a 20 ft long by 10 ft wide section by 4 inches requires about 2.5 cubic yards (20 x 10 x 0.333 ft = 66.6 cu ft = 2.47 cu yd). Ask Hello Gravel for a local per-yard or per-ton quote and multiply by the cubic yards; remember our minimum order is 3 tons and compaction may increase the amount needed.

No, you should avoid placing loose fill dirt directly over uncompacted organic topsoil. For stable results in Mountain Green's climate, remove or scarify organic layers, place fill in thin lifts, and compact each layer. If the fill will support pavement or structures, use compacted, non-organic fill and follow any engineer or local code requirements.

Fill dirt weight varies with moisture and composition, but in West Utah 1 cubic yard commonly weighs about 1.1 to 1.4 tons. That means 10 cubic yards will often weigh roughly 11 to 14 tons, which affects truckloads and pricing. Get a supplier quote through Hello Gravel so we can match a local truck size and provide an accurate delivery price.

No, the 10/20/30/40 rule refers to aggregate proportions for certain concrete mixes and is not a guideline for fill dirt. For slab subgrade in Mountain Green, use compacted, non-organic fill or engineered fill as specified by your structural engineer; do not substitute loose fill dirt for a proper base under concrete.

A typical tri-axle dump truck used by our suppliers in Mountain Green carries about 8 to 12 cubic yards of loose fill dirt, depending on material moisture and truck size. Divide your project cubic yards by the truck capacity to estimate truckloads and remember our minimum order is 3 tons, which may be less than a full truck. Request delivery options in checkout and we will match you with an appropriate local truck.

No, 2 inches of fill dirt is generally not enough for most driveway preparations. For grading and to avoid settling in West Utah's freeze-thaw conditions, aim for at least 4 to 8 inches of compacted fill and follow with a proper gravel base before paving or using the surface. Compaction between lifts is essential to reduce future settlement.

One cubic yard equals 27 cubic feet. At 4 inches deep (0.333 ft) it covers about 81 sq ft, at 6 inches (0.5 ft) about 54 sq ft, and at 12 inches (1 ft) about 27 sq ft. Use these conversions when planning fill for yards or small grading projects in Mountain Green and round up to allow for compaction and waste.