Fill Dirt in West End, TX

Fill dirt is usually less expensive per cubic yard than decorative gravel because it is a basic soil used to raise grades rather than a finished surface. In West End you’ll often see lower prices for locally sourced fill dirt due to regional availability, but final cost depends on delivery distance, truck size, and how much processing (screening or clean fill) you need.

Gravel can raise grade but it behaves differently than fill dirt: gravel drains and won't compact as tightly as clean fill, so it is better for drainage or base layers than bulk structural fill. For projects where you need stable, compacted earth (yard grading, building up under sod), use fill dirt and reserve gravel for bases and drainage layers.

A typical tri-axle dump truck used in our area carries about 10 to 12 loose cubic yards of fill dirt, though truck sizes vary. Hello Gravel’s minimum order is 3 tons, which is roughly 2 to 3 cubic yards depending on moisture and soil type; check your quote for the exact truck and yardage being delivered.

Prices vary by supplier and delivery distance, but as a rough guide delivered fill dirt in the Texas region often ranges from about $20 to $60 per cubic yard. That translates to roughly $200 to $720 for a 10- to 12-yard tri-axle truckload, with final pricing shown at checkout on Hello Gravel based on your zip code and delivery options.

Fill dirt is used to raise the grade or bring a driveway to the proper elevation before installing structural base materials. It should be placed and compacted in lifts, then topped with compactable base rock or crushed stone; finish driving surfaces with gravel or pavement rather than leaving fill dirt exposed.

You can place fill dirt on existing soil, but for best results put it down in 4- to 6-inch lifts and compact each lift to avoid future settling. Placing fill dirt on top of gravel is usually not recommended if you need a stable, compacted base; gravel belongs above fill dirt for drainage and load-bearing sections.

For most grading and under-sod work in West End, compact each layer until firm—contractors commonly compact to 90% of standard proctor density where specified. If your project will carry structural loads (driveways, foundations) follow engineer specs; otherwise, compact in 4- to 6-inch lifts with a plate compactor or roller for best results.

One cubic yard is 27 cubic feet. Depending on your wheelbarrow size (standard homeowner wheelbarrows are often 3 to 6 cubic feet), plan on about 9 to 15 wheelbarrow trips to move one cubic yard of fill dirt.

One cubic yard is roughly a 3 ft by 3 ft by 3 ft cube, about 27 cubic feet. For perspective, it will cover a 10 ft by 10 ft area about 3 inches deep, so calculate coverage based on the depth you need for your West End project.

Weight varies with moisture and soil type, but fill dirt in West End’s clay-lean soils typically weighs about 2,000 to 2,700 pounds per cubic yard. That equals roughly 1.0 to 1.35 tons per cubic yard, so confirm exact ton-to-yard conversion with your Hello Gravel quote.

No. Fill dirt holds water and is not suitable for drainage features. For drainage trenches and French drains use clean gravel or crushed stone; place fill dirt above or beside drainage layers only as needed and avoid using it inside the drain itself.

The most cost-effective approach is to order only the fill dirt volume you need, compact it in lifts, and then add a thin layer of compactable base rock rather than relying on dirt alone for the wearing surface. Using locally sourced fill dirt from Hello Gravel and planning delivery to minimize spread work can lower costs, but remember that a dirt-only surface will not hold up as a driveway without a proper base and surfacing.

Contact Hello Gravel as soon as possible to request changes; we’ll try to accommodate modifications before the order is dispatched but changes are not guaranteed. You can request tailgate spreading at checkout, and drivers in West End may provide it at their discretion, but this service cannot be guaranteed.