Fill Dirt in Kessler, TX

Prices vary by supplier, truck distance, and volume, but in the Texas region fill-dirt commonly runs about $10 to $35 per ton delivered (roughly $10 to $25 per cubic yard). Hello Gravel shows transparent, location-based pricing at checkout—check your zip code for exact rates and remember our minimum order is 3 tons.

Hello Gravel connects you with trusted local suppliers that serve the Kessler area; specific suppliers and fees vary by zip code. Typical supplier minimums run 3 to 10 tons, and delivery fees depend on distance, truck type, and order size—review the quote on our site for exact supplier details and any delivery charges.

Fill-dirt can raise grades to direct water away from structures, but most fill-dirt (especially clay-rich Texas soils) does not improve drainage on its own. For drainage improvement, contractors usually pair fill-dirt for grade with a layer of granular material or a drainage system (French drain, pipe, or crushed stone) to move water away and reduce washout risk.

To raise 1,000 sq ft by 3 inches you need about 250 cubic feet, which is roughly 9.3 cubic yards. Allow for compaction and settling by ordering 10 to 12 cubic yards (roughly 11 to 14 tons depending on soil density) and remember Hello Gravel's minimum order is 3 tons.

Contractors place fill-dirt in lifts (usually 4 to 6 inches), moisture-condition each lift, and compact with a plate compactor or roller until the required density is met. They also prep the subgrade, use geotextile fabric over soft spots, maintain positive slope away from buildings, and may test compaction if a building permit or structural work is involved.

Fill-dirt is cheaper per ton but is not a structural driveway material—it settles and can rut under traffic. Crusher-run or road base costs more but compacts to a stable, load-bearing surface and lasts longer as a driveway base; for a driveway in Kessler we usually recommend road base or a crusher-run top layer over properly compacted subgrade rather than using fill-dirt alone.

Yes. Cooler, drier months (late fall through early spring) are usually better for delivery and compaction because the ground holds moisture more consistently and rain interruptions are fewer. Summer heat can dry material and make compaction harder, while heavy rain events in spring or fall can delay work or cause washouts—plan around local weather and allow extra time during storm seasons.

Rules vary by municipality and HOA. Minor backyard grade changes often do not need a permit, but front-yard grading, changes to drainage patterns, or work near public right-of-way commonly require permits and HOA approval; check Kessler-area city permitting and your HOA covenants before ordering and contact our team if you need help identifying local requirements.

Properly placed and compacted fill-dirt used to raise grades or fill low spots can last for many years, but expect some initial settling in the first 6 to 12 months. Exposed areas subject to surface erosion, heavy traffic, or concentrated runoff may need touch-ups or top dressing every 1 to 5 years depending on conditions and maintenance.

Contractors commonly use an excavator or skid steer for placement, a plate compactor or vibratory roller for compaction, and sometimes a small bulldozer for spreading. They also recommend geotextile fabric over weak subgrades, edging to retain material, drain pipe or rock for drainage trenches, and a finish layer of crusher-run or road base where a stable surface is needed.