Fill Dirt in Jacksonville, TX

Prices for fill dirt in Jacksonville typically vary by supplier and material quality. Expect a rough range of $10 to $30 per ton, which converts to about $12 to $36 per cubic yard using a common conversion of 1.2 tons per cubic yard; your actual cost will depend on local supply, truckload size, and whether delivery fees apply. Hello Gravel lists a 3-ton minimum and shows delivery fees and options at checkout, so check your zip code for exact pricing and any free-delivery offers.

Fill dirt is usually fine-grained and is best for raising grade or backfilling, not as a finished driveway surface. For driveways and pads in Jacksonville, use screened, well-graded fill for subgrade and then place a compactable base (crushed limestone or road base) for the driving surface; the screened fill helps compaction in West Texas heat while the crushed base improves drainage and wear. Avoid using loose, unscreened fill as the top layer because it will rut and wash out during heavy rains.

To raise 100 sq ft by 6 inches you need about 1.85 cubic yards of material (100 ft2 x 0.5 ft = 50 ft3; 50 / 27 = 1.85 yd3). Using a typical fill-dirt density of roughly 1.2 to 1.6 tons per cubic yard, that equals about 2.2 to 3.0 tons. Order 10–15% extra to allow for compaction and settling, and remember Hello Gravel's 3-ton minimum will often cover this small job.

In Jacksonville's regional conditions, fill dirt with high clay content can shrink and crack during hot, dry spells and become slick or unstable when saturated by heavy rain. Proper compaction, good grading to promote runoff, and using screened or mixed granular fill reduces shrink-swell and improves stability. For sites with runoff concerns, add subdrains, slope away from structures, or use coarser material in the top layers to improve drainage.

Local suppliers include regional quarries, landscape suppliers, and municipal recycling yards, but availability varies by neighborhood and season. When ordering through Hello Gravel you will be matched with trusted local suppliers and contracted haulers; our platform typically enforces a 3-ton minimum per order. Check your zip code on Hello Gravel to see specific supplier options, availability, and lead times for Jacksonville.

For foundation backfill, screened fill dirt is generally recommended because it compacts more evenly and reduces the chance of voids or large debris that cause settlement. For septic drain fields, fill dirt is usually not the right material—percolation-friendly sand or gravel is typically required, and local codes vary, so consult your septic installer or county health department before using any fill dirt. Screened fill offers more predictable compaction for trenches and utility backfill around Jacksonville homes.

A driveway surfaced only with fill dirt will need frequent upkeep and may develop ruts or erosion after heavy rains; it is not a low-maintenance long-term surface. If you use compacted screened fill as a base and top it with a durable surface like crushed limestone or recycled concrete, expect reasonable performance—often 5 to 15 years between major repairs—with routine grading and occasional topping. Plan on periodic maintenance (regrading, adding material, and addressing drainage) and factor those costs into your project budget.

Fill dirt is cost-effective for raising grade and backfill but has poor surface durability and drainage compared with crushed materials. Crushed limestone provides a stable, drainable base and is commonly recommended in Texas for driveways; crushed concrete is a recycled alternative that performs similarly in compaction and cost but may have more fines depending on the source. For most Jacksonville driveways use fill dirt only to adjust elevations or backfill, and use crushed limestone or crushed concrete as the compacted base and driving surface.