Fill Dirt in Elmendorf, TX

In Elmendorf you can generally expect fill dirt to run about $8 to $18 per ton, depending on supplier and moisture content. That converts roughly to $10 to $22 per cubic yard loose; local truck sizes and compaction affect the final delivered volume, so prices vary by supplier and delivery distance.

Hello Gravel has a minimum order of 3 tons and delivers via local contracted dump trucks. Many orders qualify for free delivery depending on zip code, but where a fee applies in West Texas it commonly ranges from around $25 to $150 depending on distance, truck access, and next-day service requests.

Fill dirt is intended as a subgrade or to raise ground levels and is not a durable wearing surface for driveways. For a driveway you should place compacted road base or crushed stone over the fill dirt; otherwise the surface will rut, dust, and erode quickly under vehicle traffic.

For subgrade fill, specify clean, non-organic fill with minimal oversized rock and no topsoil; particle sizes will be fines-dominant, but select fill or engineered fill is better than loose topsoil. Compact fill in 6- to 8-inch loose lifts to about 90% to 95% standard Proctor (relative compaction), testing with spot checks where the driveway will bear traffic.

Hot, dry conditions in West Texas increase shrinkage and dust from fine, clay-rich fill dirt and can make freshly placed fills prone to cracking as they dry. Proper compaction, moisture conditioning at placement, and covering with a base material or mulch will reduce settling, erosion, and dust issues.

Permitting rules vary by location, so check with the City of Elmendorf and the county planning or building office before importing large volumes, especially if you are changing grade, working in a floodplain, or are in an HOA. Simple small deliveries often have no special permit, but larger grading or retaining-wall work usually requires approval or permits.

If you only have fill dirt delivered and spread with compaction, expect roughly $0.50 to $1.50 per square foot for typical residential volumes and modest sites. For a complete driveway build—grading, geotextile, compacted base, and surface gravel—typical turnkey pricing in West Texas is closer to $2.00 to $6.00 per square foot, varying with site access and material choice.

Better alternatives for driveway surfaces include road base (engineered crushed rock), crusher run, and 3/4-inch crushed limestone; these materials compact well, shed water, and resist rutting compared with raw fill dirt. They cost more than basic fill dirt—expect road base or crusher run to run higher per ton—but they lower long-term maintenance and improve drainage and load-bearing performance.

Measure the area in square feet, multiply by the desired depth in feet, then divide by 27 to get cubic yards (area x depth / 27 = cubic yards). Multiply cubic yards by about 1.1 to 1.3 to estimate tons for loose fill (1.2 is a common factor), then round up to allow for compaction and waste.

Hello Gravel connects you with local suppliers and haulers serving Elmendorf and West Texas through our online marketplace, and you can view quotes and delivery options after entering your zip code. For installation, contact local excavators, landscape contractors, or county-licensed graders for bids, and ask for references, proof of insurance, and local experience with West Texas soils.