Fill Dirt in Chambers County, TX

Fill-dirt is clean, compactable soil used to raise grade, fill low spots, or level lots. In Chambers County it is commonly used for lot grading, raising elevation above seasonal high water, and preparing building pads, but it is not typically a finished surface for driveways or landscaping without topsoil or base material on top.

Delivered prices vary with haul distance, site access, and moisture, but expect roughly $10 to $35 per cubic yard (about $8 to $25 per ton) in Chambers County. Exact pricing is shown at checkout on Hello Gravel after you enter your address because local suppliers and trucking costs are the main drivers.

Hello Gravel connects you with local suppliers and contracted haulers that serve Anahuac, Winnie, Mont Belvieu and surrounding areas, so you can get quotes from vendors that operate nearby. If you prefer, call our team at 855-241-8884 or check availability on the Hello Gravel site to see specific suppliers for your zip code.

In Chambers County's coastal plain and clay soils, fill-dirt can hold water and compress more than sandy material, so it often requires careful placement and compaction. Expect more settlement and slower drainage near the coast or in high-water-table areas; for structural work consider engineered fill, compaction in lifts, or mixing with sand/gravel to improve drainage.

One cubic yard equals 27 cubic feet and typically covers about 108 sq ft at 3" depth, 54 sq ft at 6", and 27 sq ft at 12" depth. Using an approximate conversion of 1 cubic yard ≈ 1.2 tons, one ton of fill-dirt covers roughly 90 sq ft at 3", 45 sq ft at 6", and 22.5 sq ft at 12"; actual coverage will vary with moisture and compaction.

You may need permits depending on location and intent: work in regulated floodplains, wetlands, or near county or state right-of-way often requires approval. Check with Chambers County permitting offices and the city where your property sits (Anahuac, Mont Belvieu, etc.), and for coastal or wetland work contact state or federal agencies; structural fill for building pads may also require an engineer's sign-off.

Fill-dirt alone is not recommended for driveways because it does not provide a stable, well-draining surface and will rut in wet weather common to Chambers County. Crushed stone, crusher run, or compacted base rock are better for driveways; although they may cost more per ton, they are more cost-effective long term because they compact and shed water better in local clay and high-humidity conditions.

Clear the truck path, mark the preferred dump location with flags or stakes, remove low-hanging wires or obstacles, and confirm access for a tri-axle dump truck. Note any soft or flooded areas that could prevent dumping, request tailgate spreading at checkout if desired (drivers decide on arrival), and schedule deliveries with Hello Gravel so suppliers know site conditions in advance.

Some settlement is normal—loose placed fill-dirt can settle 5% to 20% or more depending on soil type and moisture, with clay and wet ground settling more. For landscape-level grading homeowners can compact with a plate compactor in thin lifts, but for building pads, driveways, or areas requiring engineered grades hire a contractor or geotechnical engineer to specify lift thickness, moisture control, and compaction testing.