Fill Dirt in Aubrey, TX

Fill dirt is native soil with minimal organic material used to raise or level ground, backfill foundations, and build up grades. In Aubrey’s West Texas conditions it’s commonly used to build up yards, level lots before landscaping, and fill low spots before laying driveways or patios. Because it does not perform like engineered base material, it’s best for non-structural grading unless properly compacted and tested.

To raise 1,000 sq ft by 3 inches you need about 9.3 cubic yards (around 12 tons). For 4 inches you need about 12.3 cubic yards (around 16 tons). These estimates assume typical fill dirt density (about 1.3 tons per cubic yard); order 10–15% extra for compaction and settlement.

Delivered prices fluctuate with supplier, haul distance, and screening, but in North/West Texas expect a wide range. For a reliable, up-to-date cost for your address, use Hello Gravel to get real-time quotes from local suppliers, since exact delivered pricing depends on accessibility and order size. We recommend comparing at least two quotes to account for regional variation.

Hello Gravel connects you with trusted local suppliers and hauling fleets that serve Aubrey and Denton County. Minimum orders commonly start at Hello Gravel’s platform minimum of 3 tons, but some local providers prefer 5–10 tons or a minimum cubic yardage for residential dump truck runs. Confirm minimums and access requirements at checkout so the carrier can plan the correct truck type and drop location.

Hot, dry summers cause shrinkage and dust if material is too dry, while occasional heavy rains can trigger erosion or uneven settling on loose fills. Proper compaction, moisture conditioning during placement, and positive grading away from structures reduce post-delivery problems. Consider erosion control (silt fence, temporary mulch) for large fills during storm season in Denton County.

Contractors place fill dirt in 4–6 inch lifts and compact each lift with a plate compactor or roller to reach a firm, dense layer; engineered jobs may specify 90–95% Standard Proctor. For driveways and slab subgrade, they often replace top layers with a granular base (crusher run or road base) to improve drainage and load capacity. If the fill supports a structure, a geotechnical recommendation and testing may be required before pouring concrete.

Rules vary by project size and location, so contact the City of Aubrey and Denton County before placing large fills. Many municipal and county codes require a grading or fill permit if you alter drainage, exceed certain cubic yards, or change lot elevations; HOAs can add separate restrictions. Check with local planning or permit offices and include permit needs in your project timeline.

Contractors in the Aubrey area often use crusher run or road base under driveways because those mixes compact well and shed water, providing a more durable surface than plain fill dirt. Decomposed granite is popular for pathways and xeriscape areas but is more decorative and can migrate if not edged; clean fill sand is used for utility backfill but is poor as a finish subgrade. Fill dirt is usually the least expensive per ton for bulk raising, but you may need to pair it with a granular base for long-term performance, which raises overall cost.

Hello Gravel deliveries to Aubrey usually use tri-axle dump trucks; standard delivery is 2+ business days with next-day available for orders placed before noon CST. Fees and constraints depend on access (turning radius, overhead wires, street unloading), minimum order size, and whether tailgate spreading is requested—drivers perform spreading at their discretion. Seasonally, demand and wet-weather conditions can affect lead times and truck access, so schedule ahead of busy summer months and after heavy rains.

To reduce settlement, place fill in thin lifts and compact each layer properly, control moisture during placement, and allow time for any organic matter to decompose before final grading. For driveways and slab areas, replace top lifts with a compacted granular base and consider geotextile fabric over soft subsoils. If you expect structural loading, have a local engineer or geotechnical report specify compaction criteria and testing requirements.