Fill Dirt in Barberton, OH

Costs vary by supplier, distance, and load size, but a single dump-truck delivery of fill dirt in Barberton commonly runs between about $250 and $650. That range reflects small haul distances and local tri-axle loads on the low end, and longer hauls, higher moisture content, or small orders on the high end. For an exact price, get a quote through Hello Gravel (enter your zip code) since we display local supplier rates and delivery fees.

In the Barberton/West Ohio area, delivered fill dirt typically runs roughly $10 to $35 per ton, which converts to about $12 to $45 per cubic yard depending on material density and moisture. Prices depend on local supplier, distance from source, and order size; larger orders usually lower the per-ton price. Use Hello Gravel's checkout or call our team for a firm, location-specific rate.

A common tri-axle dump truck used in Barberton typically carries about 12 to 16 cubic yards of loose fill dirt. Depending on the dirt's density and moisture, that translates to roughly 14 to 20 tons. Exact capacity can vary by truck and material, so Hello Gravel lists the estimated truck size on each order and will confirm before dispatch.

Possibly, but it depends on the truck's payload and bed volume. One ton of fill dirt is roughly 0.8 to 1.4 cubic yards depending on composition, and a full-size pickup bed usually holds about 0.5 to 1.0 cubic yards safely. Always check your truck's payload rating and local road/load limits before loading; if in doubt, opt for a small trailer or a professional delivery.

Use this quick guide for 1,000 sq ft: 2 inches = about 6.17 cubic yards; 4 inches = about 12.35 cubic yards; 6 inches = about 18.52 cubic yards. Converting to tons (typical fill dirt ~1.2 tons/yd3) gives approximate tonnages of 7.4 tons (2u0022), 14.8 tons (4u0022), and 22.2 tons (6u0022), with a realistic range of about 6.8–9.3, 13.6–18.5, and 20.4–27.8 tons respectively depending on density and moisture. Order a little extra (5-10%) to allow for compaction and grading.

One cubic yard equals 27 cubic feet. A typical contractor wheelbarrow holds about 3.5 cubic feet, so 1 cubic yard is roughly 7 to 8 wheelbarrow loads. If your wheelbarrow is smaller (around 2.5 ft3) you should expect closer to 10 or 11 loads, so measure your wheelbarrow to plan labor accurately.

Yes, fill dirt is generally cheaper than topsoil because it is not screened or amended for planting. Use fill dirt for bulk backfill, grading, and raising low areas where vegetation is not required. For planting beds, lawns, or areas needing good drainage and nutrients, choose topsoil or a topsoil/fill blend instead.

No, 2 inches is not sufficient for a driveway base. For a stable driveway you should prepare a compacted subgrade and typically add 4 to 8 inches of compacted granular fill or crushed stone as the structural base before the surface material; fill dirt alone does not provide adequate load-bearing or drainage. If you are using fill dirt to raise grade, place it below the engineered base and compact it in layers to avoid future settling.

Cheapest options include ordering the minimum commercial size (Hello Gravel minimum is 3 tons), scheduling standard delivery (2+ business days) instead of next-day, and ordering larger consolidated loads to reduce per-ton freight. Some suppliers may offer consolidated or shared loads for nearby customers—ask our team—though availability depends on routing. Always compare the delivered per-ton price rather than just the material price, since delivery distance is the main cost driver.

Spring through early fall is the most predictable time to order, since trucks run more reliably and ground is easier to grade and compact. Winter in Barberton can cause scheduling delays and extra fees because frozen or muddy sites are harder to work with; very high demand periods in spring can also create lead times. To avoid delays and lock better pricing, schedule ahead and choose standard delivery windows when possible.