Fill-dirt in Severance, CO

Typical delivered prices for fill-dirt around Severance vary based on source and distance but often run roughly $10 to $30 per ton (about $8 to $23 per cubic yard). Factors that change the price include haul distance from the pit, truck access at your site, seasonal demand, and whether the material is screened or contains organics. For an exact delivered price to your address, get a quote on Hello Gravel so we can match you with local suppliers.

Yes. West Colorado freeze-thaw cycles can cause loose, fine fill-dirt with organics or moisture to settle or heave, which leads to uneven driveways and slab movement. To reduce risk, use low-fines, well-draining material, place it in thin lifts, and compact each lift per project specs; for critical foundations, follow an engineer's recommendation. Check local frost-depth guidance (commonly around 2 to 3 feet in northern Colorado) when designing footings and subgrade.

For structural work in Severance, contractors typically use granular or engineered fill rather than loose topsoil; specs frequently reference AASHTO/ASTM classifications and require compaction to about 95% of Standard Proctor (ASTM D698) unless an engineer specifies otherwise. If using fill-dirt, make sure it is free of large organic material, debris, and oversized rocks and place it in 4- to 8-inch lifts with compaction equipment. Local building plans or engineers may call for specific gradation charts or field density tests (nuclear or sand cone) before backfill or slab pours.

Use this rule: cubic yards = area (sq ft) * depth (in) / 324; convert to tons by multiplying cubic yards by about 1.3 for typical compacted fill-dirt. For 1,000 sq ft: 4 inches ≈ 12.3 yd3 (≈ 16 tons); 6 inches ≈ 18.5 yd3 (≈ 24 tons); 8 inches ≈ 24.7 yd3 (≈ 32 tons); 12 inches ≈ 37.0 yd3 (≈ 48 tons). For smaller areas, multiply the per-square-foot factor (4 in ≈ 0.0123 yd3/sq ft) by your area to calculate needs.

Common alternatives are crushed stone (3/4u0022 minus, road base) and engineered structural fill; crushed stone gives better drainage and load-bearing performance while engineered fill is specified for structural projects. Costwise, plain fill-dirt is usually the least expensive, recycled concrete or reclaimed base can be similar or slightly higher, and crushed stone or engineered fill tends to cost more due to processing and material value. For driveways and foundations in Severance's climate, investing in a granular base often reduces long-term maintenance compared with loose fill-dirt.

Yes. Severance and Weld County can have weight limits on residential streets, HOA rules, and seasonal road restrictions that affect delivery. Hello Gravel commonly uses tri-axle dump trucks; if access is tight, has low-clearance utilities, or there's a bridge or narrow lane, let us know so we can arrange an appropriate truck or smaller delivery. Permits for overweight or oversized loads are handled by the supplier/hauler when required, so we will coordinate those details if needed.

Many residential permits in northern Colorado require documentation for structural backfill and subgrade, which can include compaction tests or engineer-specified materials for footings and slabs. Requirements vary by project and permit type, so contact the Severance building department or your project engineer early; for critical work you should expect to provide proctor and field-density test results. Hello Gravel can help source materials that meet common municipal and engineer specs, but final approval is up to the local inspector.

Used alone as a surface, fill-dirt tends to rut, wash, and require frequent grading; lifespan as a finished surface can be short in wet seasons. When used as a base and capped with crushed stone or road base, it can perform well for many years with occasional regrading and refill of washouts. Regular maintenance in this climate usually means regrading after major storms and topping with additional aggregate every few years depending on traffic.

Yes. Adding fill-dirt can change surface runoff patterns and may cover or interfere with septic drain fields and leach lines, potentially causing system failure or contamination. Always maintain required setbacks from septic components and follow local health department rules; use clean, low-organic fill and design drainage to move water away from foundations and septic areas. If your site is near a regulated waterway or wetland, check county stormwater rules before placing large volumes of fill.

Start with Hello Gravel: enter your zip code to see local suppliers and get delivered quotes for clean fill-dirt, recycled concrete, and other base materials. Recycled materials are accepted for many driveway and grading uses, but suitability depends on local codes and whether the material meets structural and environmental specs; some projects or inspectors require virgin or engineered fill. If you need material for structural backfill or a permitted foundation, tell our team so we can match you with suppliers that provide testable, approved products.