Fill-dirt in Broomfield, CO

Hello Gravel connects you with local Broomfield-area suppliers and haulers so you can get quotes from vendors sourcing material nearby. Typical delivered fill-dirt pricing in the Broomfield/West Colorado area commonly ranges from about $12 to $30 per cubic yard (roughly $8 to $20 per ton depending on soil density), though exact price depends on source, haul distance, and volume. We recommend getting a firm quote through our site and checking any minimum order (Hello Gravel minimum is 3 tons).

Many local deliveries within the Broomfield area include standard delivery in the base price, but fees can apply for long hauls, tight access, or next-day service. When fees are charged, expect delivery surcharges roughly in the range of $0 to $15 per ton or a flat truck fee of $50 to $200, while optional tailgate spreading—when available—typically runs $30 to $150 depending on yard size; drivers perform spreading at their discretion. Always request delivery details and any spreading service at checkout so you know what to expect.

You may need permits for significant grading, changes to finished grade, or work that affects stormwater or drainage; Broomfield’s planning and building department regulates grading, erosion control, and changes to floodplains. Small landscaping fills often do not require permits, but anything that changes lot drainage, raises grade near property lines, or exceeds local thresholds can trigger a permit and plan review. Before ordering large volumes, check with the City and County of Broomfield Planning and Building Division and any HOA rules to confirm permit needs.

For driveways use a well-graded, compactable fill with a mix of sand and small gravel (commonly called granular fill) topped with a structural aggregate layer; avoid uncontrolled organic topsoil. For foundations and structural fills use clean, non-organic fill free of roots and debris and place in engineered lifts with compaction; your project may call for 3/4u0022 minus or engineered structural fill per a geotechnical recommendation. For drainage zones choose free-draining material such as crushed stone or clean gravel rather than fine silty fill, especially important in Broomfield’s freeze-thaw cycles.

A commonly used target for compacted fill is about 95% of Standard Proctor, which translates roughly to a compacted unit weight in the range of 100 to 120 lb/ft3 (about 1.5 to 1.6 tons per cubic yard depending on moisture and material). Properly placed and tested fill normally settles only a small percentage after compaction, but uncontrolled fills can experience greater settlement; as a rule of thumb many contractors add about 10% extra material to allow for compaction and minor settlement. For critical structures, get a geotechnical report and require compaction testing to set exact density and allowance.

Measure the area (length x width x depth) in feet to get cubic feet, divide by 27 to convert to cubic yards, and then add a compaction allowance—commonly 5% to 15% depending on how the material will be placed and compacted. If you prefer weight-based ordering, a practical conversion for fill-dirt in this region is about 1.2 to 1.6 tons per cubic yard; use Hello Gravel’s material calculator or request a supplier conversion to confirm. When in doubt, order a small extra buffer or consult a contractor so you don’t run short mid-project.

Tri-axle dump trucks are the typical delivery vehicle, so ensure adequate road width, turning room, and overhead clearance; tight lanes, low branches, or vehicle weight limits on approach roads may require offloading at the curb or re-handling. Notify us of gated entries, narrow streets, or culverts; you may need permits from Broomfield for temporary street blocking or right-of-way use. Also indicate any spread preferences in the Order Notes and be aware that tailgate spreading is at the driver’s discretion for safety reasons.

Late spring through early fall is generally best in Broomfield because soils are drier and compaction equipment achieves consistent results; avoid placing large fills on frozen ground or during the spring thaw when soils are saturated. Winter deliveries are possible but can be slower and may compromise compaction quality or require special handling. Plan seasonal timing with your contractor and supplier to reduce settlement and rework risks.

Yes for any structural work (foundations, retaining walls, large grade changes) you should use a geotechnical engineer to specify acceptable fill, compaction requirements, and testing frequency. For small landscaping fills a contractor’s standard compaction may suffice, but request material source information to confirm it is free of organics and debris. Hello Gravel can supply material details and you can arrange compaction tests through local testing labs if required by your project or permits.

Because Hello Gravel sources materials regionally, color and texture will reflect Broomfield’s local geology and can vary from batch to batch; photos are representative but not exact matches. You can add preferences in Order Notes and ask suppliers for material descriptions or photos before delivery, but exact color and particle mix cannot be guaranteed. If appearance is critical, request a sample or visit the supplier yard prior to ordering.