Fill Dirt in Paxon, FL

Fill-dirt is subsoil (low in organic matter) used to raise grade or fill depressions. In Paxon and much of Florida, fill-dirt often contains sandy or clayey material depending on local geology, so it may drain quickly or hold moisture differently than topsoil. It is not intended for planting without a topsoil layer on top.

Price varies by supplier and delivery distance, but most Paxon customers pay roughly $10 to $30 per cubic yard delivered, depending on material quality and truck access. Get an exact quote on checkout for your zip code since local supply and hauling fees affect the final price.

A common tri-axle dump truck carries about 12 to 16 cubic yards loose, while larger end-dumps can carry 18 to 25 cubic yards. Exact capacity depends on the truck type used for your delivery; Hello Gravel will list estimated load size on your order confirmation.

Measure the area (length x width) and the desired depth in feet, then multiply and divide by 27 to convert cubic feet to cubic yards: (L x W x depth)/27 = cubic yards. For example, a 20 ft x 50 ft area raised by 3 inches needs about 9.3 cubic yards ((20*50*0.25)/27).

Yes, fill-dirt is commonly used to level yards, build grades, and fill low spots, but it should be placed in layers and compacted to avoid future settling. Because Paxon has a relatively high water table in places, plan for drainage and add a top layer of topsoil for any lawn or planting.

Use fill-dirt to build grade, raise foundations, or under hardscapes where structural stability matters. Use topsoil where you want plants or lawn to grow; topsoil contains organic matter and nutrients that fill-dirt lacks. Often projects use fill-dirt first, then cap with several inches of topsoil for planting.

Not by itself. Fill-dirt typically lacks organic matter and nutrients and may compact or drain poorly for roots, so it should be covered with 4 to 6 inches of good topsoil or a topsoil/compost mix before planting in Paxon soils.

Small repairs can be DIY with wheelbarrows, hand tools, and a rented plate compactor, but larger jobs usually need a skid steer or small excavator and compaction equipment. Hiring a contractor can save time and ensures proper compaction and grading, which is especially important given Paxon’s local drainage and soils.

Yes, check with Paxon/Clay County planning and stormwater authorities before large fills; permits or erosion-control measures may be required, especially if you change drainage patterns or are in a flood zone. Also call 811 to locate underground utilities before any digging or heavy spreading.

Place fill in thin lifts (4 to 8 inches) and compact each lift with a plate compactor or roller to reduce future settling. In sandy soils common around Paxon, compaction is easier but avoid overwatering; in clayey patches, allow proper drying between passes to get consistent compaction.

That example requires about 9.3 cubic yards of fill-dirt. At a typical delivered rate of $10 to $30 per cubic yard, material cost would be about $93 to $279, plus delivery and spreading/compaction labor—expect a total project price higher after hauling and machine time are added. Get a full quote from Hello Gravel for accurate local pricing and truck fees.

A 7x14 dump trailer will generally carry roughly 7 to 11 cubic yards depending on side height and how full it is. Trailer capacities vary, so confirm the trailer’s volume or weigh tickets if precise amounts are important for your Paxon delivery.

It can be reasonable depending on the skill level and equipment included; $100/hour is common for an operator with a skid steer or small excavator plus trailer and tools. Always get written estimates that spell out what’s included (machine time, operator, disposal) and compare a few local contractors.

Yes—adding fill changes how water flows across your lot, and improper placement can increase runoff onto neighbors or worsen ponding. Before major fills in Paxon, plan grading to direct water away from structures and follow local stormwater rules or consult a contractor to avoid unintended flood risk.

If you plan to plant, avoid relying on fill-dirt alone—mixing a small amount into existing topsoil is okay, but better practice is to cap fills with topsoil or a planting mix. The 70/30 rule generally refers to using about 70% topsoil and 30% compost for planting mixes; fill-dirt should not replace that topsoil component in planting areas.