Fill-dirt in Pasco, WA

Prices for fill-dirt in Pasco typically vary by source, moisture, and delivery distance. Expect a delivered range of about $15 to $45 per ton (roughly $18 to $55 per cubic yard), but rates can be lower for large orders or higher if a long haul or tight residential access is required. For an exact quote to your address in Pasco (zip code specific) use our site to check availability and final delivered pricing.

Use volume = area x depth. For 1,000 sq ft you would need about 6.2 yd3 (8–10 tons) for 2u0022, 9.3 yd3 (11–14 tons) for 3u0022, 12.4 yd3 (15–20 tons) for 4u0022, and about 18.5 yd3 (22–30 tons) for 6u0022, with ranges reflecting differences in moisture and compaction.

Fill-dirt is an inexpensive way to raise or level grade but it is not a good finished surface for a driveway in Pasco. In our Tri-Cities climate you should use fill-dirt only as subgrade, compact it well, then install a proper base (crusher-run or road base) and a wearing surface of crushed rock. This is the most cost-effective approach that will hold up to cars, trucks, and occasional freeze/thaw.

Repairs to public streets and potholes are managed by the City of Pasco Public Works and generally require authorization or a permit; private contractors should not perform permanent repairs on public property without city approval. On private property, contractors can use fill-dirt for temporary or permanent repairs, but major grading or drainage changes may require permits from the city, so check with Pasco Public Works before starting larger projects.

Yes, Pasco contractors commonly offer compaction (plate tamping or roller) and stabilization services. Typical add-on costs depend on job size: a small residential compaction run may be $150–$600, while full driveway prep with roller or stabilizer can range from several hundred to a few thousand dollars. Ask contractors for line-item quotes for compaction, geotextile installation, and stabilization so you can compare apples to apples.

Coverage per ton varies with material density, but using a common mid-range conversion (1 ton ≈ 0.77 yd3): one ton covers about 100–130 sq ft at 2u0022, roughly 65–90 sq ft at 3u0022, and about 50–70 sq ft at 4u0022. Use these as planning estimates and order a little extra to account for compaction and grading waste.

No, 2 inches of fill-dirt is not sufficient for a driveway surface in Pasco. For a durable driveway you should plan on 4–6 inches of compacted structural fill or road base under the surface layer, and then 2–3 inches of wearing gravel on top; this stack better resists vehicle loads and seasonal movement.

Costs vary by width and prep needed; assuming a single-car driveway 12 ft wide: a 20 ft driveway (240 sq ft) commonly runs about $500–$2,000 installed for basic prep, fill, compaction, and surface gravel. A 100 ft driveway (1,200 sq ft) typically runs roughly $2,500–$8,000 installed, with higher costs if extensive grading, hauling, or drainage work is required. Get detailed quotes because site access, rock removal, and drainage can change prices significantly.

You can place fill-dirt over native soil for simple leveling, but prep improves long-term results: clear organic topsoil, remove vegetation and debris, and compact the existing soil in lifts. If the native soil is soft or wet you should add geotextile or a crushed rock base before placing large thicknesses of fill to avoid settling and drainage problems.

No fill-dirt itself will harden like concrete. If you want a stable, hardened surface consider alternatives available in the Pasco market such as crusher-run (compacted road base), polymer-stabilized gravel, or resin-bound products; these are different products from fill-dirt and should be specified when ordering.

For 1,000 sq ft to a 4u0022 fill depth you need about 12.4 yd3 of fill-dirt. Material-only delivered could run roughly $300–$700 depending on source and haul distance, while full delivery plus installation, grading, and compaction typically lands in the $1,200–$4,500 range. For an accurate estimate, get a site-specific quote through Hello Gravel and include any requested spreading or contractor line items.

Yes, Pasco has local suppliers that deliver fill-dirt to residential addresses through the Hello Gravel network. Minimum orders on our platform start at 3 tons, but most residential jobs that need leveling or driveway base will require larger deliveries; you can enter your zip code to see supplier availability and exact minimums for your address.