Fill Dirt in Milledgeville, GA

Fill dirt is clean, mostly fine-grained soil used to raise grade, level yards, and backfill foundations. In Milledgeville it’s best for non-structural fills and grading where drainage and settlement are managed; it is not a substitute for engineered base material under driveways or pads.

Prices vary by supplier and seasonal availability, but expect a rough range of $8 to $25 per cubic yard (about $8 to $30 per ton) delivered in the Milledgeville area. For an exact delivered price to your zip code, use Hello Gravel to get regional quotes—minimum order is typically 3 tons.

Multiply length x width x depth (in feet) and divide by 27 to get cubic yards. To estimate tons, multiply cubic yards by a local density of about 1.0 to 1.2 tons per cubic yard for typical fill dirt; for example, a 10' x 50' area filled 6u0022 deep is ~9.3 yd3 or ~9.3–11.2 tons.

Yes. Hello Gravel connects you with local suppliers and contracted haulers in the Milledgeville/West Georgia area and can check which vendors offer placement or compaction as an add-on. Placement/compaction availability and fees vary by supplier and are provided when you get a quote—always request the service in Order Notes so the supplier can confirm.

Most deliveries are made by tri-axle dump trucks that need roughly 10–12 ft of width, 35–45 ft of turnaround space, and about 12–14 ft of vertical clearance for dumping. Clear the drop zone of vehicles, low limbs, and soft ground; discuss any access concerns with Hello Gravel before delivery to avoid extra fees or rescheduling.

Local clay soils in Baldwin County can hold water, shrink-swell, and cause slow drainage, which increases risk of settlement and poor load-bearing when mixed with loose fill dirt. In Milledgeville’s wet summers, place and compact fill during drier periods, add drainage or sand layers as needed, and consider geotextile or engineered fill for areas with poor soils.

For general non-structural fills, place fill dirt in lifts of 6u0022 to 8u0022 and compact each lift to about 90% to 95% of standard Proctor density using a plate compactor or roller. For structural or load-bearing applications (driveway bases, foundation backfill), consult an engineer—these uses often require engineered fill or crushed stone instead of plain fill dirt.

No—fill dirt is not a good long-term driveway base because it can settle and retain moisture. Crusher run or crushed stone provides better drainage and load bearing; while fill dirt is cheaper upfront, crushed stone typically costs more but requires less maintenance and reduces settling over time.

Small amounts of fill for typical yard grading usually do not need permits, but large fills, changes to drainage patterns, or commercial work may require Baldwin County permits or erosion control plans. Check with Baldwin County planning and permitting before major grade changes or stockpiling large volumes to avoid fines or rework.

Avoid the wettest months when possible—late spring through summer can have heavy storms that make compaction difficult and lead to extra drying time. Late spring, early fall, or dry winter periods are usually better for delivery and compaction; ask Hello Gravel about seasonal availability and any off-season discounts in West Georgia.

Common add-ons include machine placement, regrading, compaction, erosion control (silt fence or straw), and installation of drainage features or geotextile fabric. Tell Hello Gravel what you need up front so suppliers can quote these services—drivers may offer limited tailgate spreading but it is not guaranteed.