Fill-dirt in Spokane, WA

Fill dirt is generally cheaper than most gravel types in Spokane because it is a lower-grade material used for raising grades and backfill rather than structural surfacing. Prices vary by supplier, delivery distance, and moisture content, so bulk ordering through Hello Gravel usually gives the best per-ton rate.

Costs vary, but expect a delivered dump-truck load of basic fill dirt in Spokane to typically run in a broad range depending on volume and site access. A single tri-axle load often costs between about $300 and $900 delivered, though the exact price depends on distance, truck size, and whether spreading or special access is required.

Fill dirt is mostly fine particles and subsoil used to build up or level ground and then compacted; it does not provide good drainage. Gravel is coarse, stone-based material used for drainage, driveways, and structural bases. In Spokane's variable soils and freeze-thaw cycles, use fill dirt to raise or level and gravel where drainage and load-bearing are needed.

Pricing depends on supplier and delivery, but as a rough example, if basic fill dirt is priced around the market rate, 2 cubic yards (roughly 2.5 to 3 tons) will often cost between about $60 and $200 delivered. Hello Gravel requires a minimum order (check site for the 3-ton minimum) and can provide an exact quote for your address in Spokane.

Calculate volume by multiplying area by depth. For example, for 1,000 sq ft at 2 inches deep you need about 6.2 cubic yards; at 6 inches deep you need about 18.5 cubic yards. Factor in 10-20% extra for compaction and grading, and consider Spokane's clay content and frost depth when choosing finished grade depth.

One cubic yard is a pile roughly 3 ft x 3 ft x 3 ft and typically weighs about 1.2 to 1.5 tons depending on moisture and soil type. On site it fills about 4-9 contractor-style wheelbarrow loads (size-dependent) and is about one-third to one-half of a standard pickup truck bed by volume when not overfilled.

A common tri-axle dump truck load in the Spokane area will carry about 10 to 14 cubic yards, which for fill dirt generally translates to roughly 12 to 20 tons depending on moisture, compaction, and local weight limits. Exact tonnage varies by truck and material; Hello Gravel coordinates truck sizes with suppliers and can confirm expected tonnage for your delivery.

Average delivered cost for a dump truck of basic fill dirt in Spokane is commonly in the $300 to $900 range, depending on load size, distance from the source, and site access. Additional charges can apply for short deliveries, difficult drop locations, permits, or last-minute scheduling.

A standard full-size pickup bed will hold about one cubic yard of loose material if filled level with the bed rails, but weight limits often make this unsafe with heavy, wet fill dirt. Check your truck's payload rating and local road limits; for larger jobs Hello Gravel’s dump-truck deliveries are safer and more practical.

You can place gravel over fill dirt for short-term use, but it is not a long-term solution without proper preparation. In Spokane's climate you should compact the fill in lifts, create a stable subgrade, and often use a geotextile or compacted base layer to prevent settling and frost heave before installing a gravel surface.

Yes, fill dirt is commonly used to level yards, but do it in layers with compaction between lifts to minimize future settling. Consider drainage, frost depth, and soil type in Spokane; if you need a finished lawn surface add topsoil over compacted fill dirt to support grass and landscaping.

The most economical approach is to order bulk local fill dirt and schedule a single delivery to your site, since per-ton pricing drops with larger volumes and shorter haul distances. Compare local suppliers through Hello Gravel, ask about reclaimed or onsite excavation material, and be aware of any delivery or offload charges that can affect the total cost.

That depends on wheelbarrow size: with a common contractor wheelbarrow of about 3 cubic feet you should expect roughly 9 loads per cubic yard; with smaller home wheelbarrows (around 2 cu ft) it’s closer to 13-14 loads. Plan on variability and add extra time if moving material by hand, especially in Spokane's seasonal conditions.