Fill-dirt in South Cheney, WA

Delivered fill-dirt prices in South Cheney commonly fall in the range of about $15 to $40 per ton depending on supplier, moisture content, and hauling distance; small orders pay a higher per-ton rate. Hello Gravel shows exact, upfront pricing for your zip code and a minimum order of 3 tons, and you can get a firm delivered quote online or by contacting our team.

For West Washington’s wet conditions, use a structural fill blend: well-graded fill-dirt compacted in lifts with a granular base or a 3/4 minus/crushed aggregate wearing course on top. Pure topsoil or loose fill will hold moisture and settle, so plan for drainage (subsurface drain or geotextile) and a granular surface layer to improve stability and compaction.

Fill-dirt can be used for non-structural backfill if placed in thin lifts and properly compacted, but it is not ideal where drainage or lateral loads matter. For foundation backfill or behind retaining walls, inspectors and engineers often prefer free-draining granular material and a drainage layer to reduce hydrostatic pressure; check permit requirements before ordering.

A 24 ft by 40 ft area at 4 inches deep is about 11.85 cubic yards. Using a common fill-dirt weight estimate (about 1.2 to 1.4 tons per cubic yard) you will need roughly 14 to 18 tons; we recommend ordering about 10 to 15 percent extra for compaction and settling, so plan on about 16 tons as a practical delivered amount.

Hello Gravel connects you to local contractors and suppliers serving South Cheney and nearby areas, with contractor-grade fill-dirt available by the truckload. Typical bulk tiers are small loads (3 to 10 tons), medium (10 to 30 tons), and large (30+ tons) with per-ton price breaks as quantities increase; request a quote on our site to see negotiated local pricing for your zip code.

For rural roads and farm access, crushed rock or compacted aggregate is generally better because it provides drainage, load-bearing capacity, and longer life under vehicle traffic. Fill-dirt is cheaper and useful for raising grade or filling low spots, but it tends to retain water and rut—use fill-dirt only as a subgrade with a crushed-rock wearing surface for best results.

Lifespan varies with drainage and compaction: well-prepared subgrade with a granular surface can last several years under light use, while surfaces of mostly fill-dirt typically require touch-ups or regrading within a season to a few years. Good drainage, a compacted base, and a crushed-rock wearing layer significantly extend service life in West Washington’s wet climate.

On slopes in South Cheney, loose fill-dirt is likely to erode during heavy rains unless you use erosion controls. Use terracing, silt fences, rock check dams, erosion-control blankets, or seeded vegetation and consider geotextile fabric or rock riprap at runoff points to prevent washing out.

Acceptance depends on the agency and the project: some inspectors accept engineered fill placed and compacted to specified densities, while others require granular backfill for utility trenches or structural areas. Always check with South Cheney or the relevant county building department for compaction testing and material specifications before ordering material.

Charges vary with material volume and site conditions; delivery from Hello Gravel is priced per load (minimum 3 tons) and mechanical spreading and grading are typically quoted by contractors at $50 to $150 per hour or a flat fee per cubic yard. As an example, moving and rough-spreading 20 to 40 tons on a 0.25-acre lot could cost roughly $300 to $1,500 total for spreading plus $200 to $800 for delivered material, so get local quotes and site visits for accurate estimates.