Fill-dirt in Home, WA

Delivered prices vary by supplier and job specifics, but in West Washington (Home, WA) expect an estimated range of about $25 to $70 per cubic yard delivered. Costs reflect local hauling, availability, and moisture/compaction of the material; request a firm quote via our site for an exact delivered price to your zip code.

A rough delivered estimate for 10 cubic yards in Home, WA is $250 to $700, though regional supply and truck routing can change that number. For accurate pricing and scheduling, enter your address on Hello Gravel to see live quotes and available suppliers.

To raise 1,000 sq ft by 2 inches you need about 6.2 cubic yards, and for 3 inches about 9.3 cubic yards (use area * inches / 324). At local delivered rates, expect a cost range roughly from $150 to $650 depending on depth and local pricing—get a precise quote through our calculator or order form.

Fill dirt can be used as foundation backfill if it is free of organic matter and compacted in lifts, but many builders prefer engineered backfill or gravel near footings for drainage. Hello Gravel partners deliver to job sites, but placement and compaction are typically the contractor or homeowner's responsibility; tailgate spreading by drivers may be available at their discretion but is not guaranteed.

Fill dirt is generally cheaper than topsoil and often less expensive than crushed gravel per cubic yard, because it contains fewer fines and no screening for planting quality. For grading and building up low spots, fill dirt is appropriate; for surfaces that need drainage or vehicle traffic, gravel or crushed rock is usually the better choice.

Fill dirt has relatively poor permeability compared with gravel and will hold more water, which can be a concern in rainy West Washington conditions. For areas requiring quick drainage—around foundations, French drains, or under driveways—order drainage rock, crushed stone, or a gravel base rather than straight fill dirt.

You can put fill dirt over existing turf, but it is best to remove grass and topsoil first to avoid rotting organic matter and uneven settlement. For lawn-leveling a few inches, spread fill dirt in thin lifts and lightly compact; for driveways or heavy loads, install a gravel base and compact in layers for long-term stability.

Costs vary widely by width, depth, site prep, and labor; as an example, a single-car 20 ft by 10 ft driveway (200 sq ft) with 6 inches of fill base is about 3.7 cubic yards and 3 inches of gravel surfacing is about 1.9 cubic yards. Using local delivered material ranges and contractor labor, ballpark total project costs can range from a few hundred dollars for materials plus a few hundred to a few thousand dollars for excavation, compaction, and surfacing—get a site-specific quote from Hello Gravel and local installers for a firm price.

Many suppliers require a minimum order (Hello Gravel's network commonly enforces a minimum of about 3 tons), so pickup of a single cubic yard may not be available from every yard. One cubic yard of loose soil often weighs around 1.1 to 1.3 tons and may not safely fit in a standard pickup truck bed — check your truck's rated payload before attempting pickup.

Fill dirt settles more and drains slowly, which can cause low spots and poor performance under vehicle loads; it also lacks the structural strength of compacted gravel. Use fill dirt to raise grades and under lawn areas, but choose crushed gravel or a compacted rock base for driveways, paths, or locations where drainage and load-bearing are priorities in wet West Washington conditions.