Gravel in Hansville, WA

Delivered gravel prices in the Hansville area usually vary by gravel type and truck distance; expect roughly $40 to $90 per ton for common driveway-grade crushed stone or crushed gravel. Local factors like quarry location, whether material is washed, and delivery logistics can push prices higher; Hello Gravel has a 3-ton minimum and often shows exact delivery fees at checkout for your zip code.

For Hansville's coastal, wet conditions choose angular crushed rock (3/4u0022 crushed stone or 3/4u0022 minus/ABC) for a stable, well-draining surface. Washed crushed rock drains better and avoids excess fines that can compact, and using a coarser base layer with a smaller wearing course on top helps resist washouts and salt-related breakdown.

A 20x30 driveway at 4u0022 depth uses about 7.4 cubic yards (600 sq ft x 0.333 ft = 200 cu ft = 7.4 yd3). Using an estimate of 1.4 tons per cubic yard for crushed rock gives about 10.4 tons, so order 11 to 12 tons to allow for compaction and waste.

Availability depends on local quarries and suppliers near Hansville; many suppliers offer both washed and unwashed products but options can be more limited in remote coastal areas. Hello Gravel connects you to nearby suppliers and the typical minimum order is 3 tons, with exact product availability and minimums shown during checkout.

In Hansville's mild maritime climate, gravel often performs better for drainage because it is permeable and lets water pass through rather than ponding on the surface. Gravel is cheaper upfront and easier to repair after washouts, while asphalt gives a smoother, lower-maintenance surface but requires good drainage design to avoid cracking and rutting over time.

Pea gravel typically requires topping up or frequent raking every 1 to 3 years because it shifts under traffic and rain. Crushed rock used as a base will often last 10 years or more with proper drainage and occasional regrading, while the wearing course (top layer) may need refresh every 3 to 7 years depending on traffic.

Kitsap County may have rules related to driveway approaches, stormwater, and erosion control, especially if your project alters drainage or connects to a county road. Check Kitsap County Public Works and building department for permits and standards before installing or expanding a driveway, and contact Hello Gravel if you need guidance on local requirements.

Installed gravel driveway costs in the West Washington/Hansville area typically range from about $3 to $8 per square foot for basic installs, so a 20x30 (600 sq ft) driveway often falls between $1,800 and $4,800 depending on site prep, edging, compaction, and material type. More extensive prep, drainage work, or premium surfacing will increase the price, so get a site-specific estimate for accurate pricing.

Design for good drainage: slope or crown the driveway so water runs off, install culverts or ditches at low points, and use a coarse, well-compacted base with a larger stone in wash-prone areas. Add edge restraints, consider geotextile fabric over unstable soil, regrade and add material after major storms, and avoid letting vehicle water concentrate down the center of the drive.

Use the formula: area (sq ft) x depth (ft) / 27 to get cubic yards; for example a 10x10 patio with a 4u0022 base needs about 1.23 cubic yards. In sandy or coastal soils common around Hansville we recommend geotextile fabric to separate the native sand from the gravel base, which reduces migration and improves longevity.