Fill Dirt in Mila Doce, TX

Costs vary, but expect a range rather than a fixed price. For material alone, fill-dirt in the Texas region commonly runs roughly $10 to $30 per cubic yard; for a typical 12.3 cubic yard job (see quantity calc below) that is about $120 to $370. Delivery with Hello Gravel often has no fee in many areas, but when charged it is usually $50 to $150 depending on distance; professional spreading and compaction by a contractor can add $300 to $900 depending on access and equipment. Always request an itemized quote through Hello Gravel so you can see material, delivery, and labor estimates for your address in Mila Doce.

Use graded, clean fill-dirt for raising grades and backfill—this is typical, locally sourced dirt with a mix of fines and clay that compacts well. For driveways and structural pads, do not leave only loose fill-dirt on the surface: compact the fill in lifts and finish with a structural base such as crusher run or 3/4" crushed stone to provide drainage and load-bearing capacity. If you need a driving surface, specify a structural base when ordering or plan to top the compacted fill with stone material from Hello Gravel.

Fill-dirt works for raising grade and backfill in Mila Doce but the local clay content and Texas heat affect performance. Clay-rich fill can shrink, swell, and crack when it dries, so it should be placed in thin lifts, moisture-conditioned, and compacted to reduce future settlement. Also plan for positive drainage and, where needed, a geotextile or mixing with sand/gravel to improve stability in areas with poor drainage.

Calculate volume first: 1,000 sq ft x 4 in (0.333 ft) = 333.3 cubic feet, or about 12.3 cubic yards. Fill-dirt typically weighs around 1.2 to 1.6 tons per cubic yard depending on moisture and composition, so that equals roughly 14 to 20 tons. A practical estimate for planning and ordering through Hello Gravel is about 16 tons, and we recommend ordering a small overage (5-10%) to allow for compaction and settling.

Installation costs depend on access, site prep, and compaction needs. Local contractors in Texas commonly charge about $30 to $75 per cubic yard for placement and compaction, so a 12.3 cubic yard job could run roughly $370 to $920 for labor and equipment; weekend or difficult-access jobs may be higher. If you hire a separate operator for a skid steer or small excavator expect daily rental/operator rates in the $250 to $600 range; get multiple local quotes and confirm whether delivery drivers will perform any tailgate spreading (driver discretion, not guaranteed).

Fill-dirt is good for raising low spots and building subgrade but it is not a durable driving surface. Crusher run or crushed rock provides a compactable, interlocking base that sheds water and handles wheel loads much better for driveways and fire lanes. For rural driveways in Mila Doce we typically recommend compacted fill-dirt to build grade, then a structural layer of crusher run or 3/4" stone on top for long-term wear and drainage.

Hello Gravel connects you with local suppliers across the Texas region that stock fill-dirt and will deliver to Mila Doce; check your zip code on the site to see available materials and suppliers. Our platform minimum order is 3 tons, and many local suppliers deliver tri-axle loads (8 to 15 tons) for large jobs; delivery fees and minimums vary by supplier and distance. Use Hello Gravel to get multiple quotes, schedule delivery (standard 2+ business days or next-day before noon CST with a fee), and add notes about placement or access.

Expect some settling in the first year after placement; inspect after major rains and the first winter. Light paths and low-traffic areas may need an annual touch-up of 1 to 2 inches of material and occasional regrading, while driveways finished only with fill-dirt will require more frequent repairs and heavier top-ups. For lower maintenance, compact properly during installation and finish with a structural stone surface; that combination reduces regrading frequency and improves durability.