Fill Dirt in Leon Valley, TX

Delivered fill dirt prices in Leon Valley typically range from about $10 to $30 per cubic yard, depending on supplier, moisture content, and whether the load is a short load. That roughly translates to $12 to $35 per ton because density varies with compaction and moisture. Hello Gravel shows exact pricing and any delivery fees during checkout after you enter your zip code.

Hello Gravel partners with local quarries and aggregate haulers serving the Leon Valley/Bexar County area, including limestone and fill dirt suppliers common to West Texas. Availability varies by zip code and seasonal demand, so check your zip on our site or contact our team for supplier options and scheduled delivery dates.

To raise 1,000 sq ft: 3u0022 requires about 9.3 cubic yards (roughly 11–12 tons), 6u0022 about 18.5 cubic yards (roughly 22–24 tons), and 12u0022 about 37.0 cubic yards (roughly 44–48 tons). Ton estimates use a common conversion range (about 1.1–1.3 tons per cubic yard) to account for moisture and compaction. Always order a small overage (5–10%) for settlement and spreading loss.

For subgrade work in Leon Valley's clay/limestone soils, use clean, well-graded fill dirt or engineered fill compacted in lifts; avoid high-organic topsoil as a structural fill. For the surface of driveways and patios, top the fill with road base or crushed limestone rather than leaving fill dirt exposed. Local caliche and limestone-based road base often performs best here because it compacts well and resists dust.

Fill dirt is suitable for bulk grading and raising low spots, but it is not a substitute for engineered drainage material or erosion-control measures. In West Texas, combine compacted fill with proper drainage paths, swales, and rock armoring where runoff is concentrated to prevent erosion during heavy rains. For final surfaces and drainage layers, use gravels, rock, or geotextile-stabilized soils as recommended for the slope and runoff conditions.

A compacted fill dirt driveway used lightly will settle and produce dust over time; expect periodic regrading and infill every 1–3 years unless you add a stabilized top layer. Longevity improves greatly if you place and compact lift layers, then surface with crushed limestone or road base. Regular maintenance includes occasional grading, adding fresh aggregate, and dust control during dry months.

Permit and HOA rules vary. Small grading or fill projects may not need a city permit, but retaining walls over certain heights and any drainage-impairing work often require permits from the City of Leon Valley or Bexar County. Check local building and zoning rules and your HOA guidelines before ordering; Hello Gravel can help connect you with local pros if you need a permit-ready plan.

Fill dirt is usually the least expensive material per yard but performs poorly as a finished driveway surface because it compacts less uniformly and creates dust. Crushed limestone and road base cost more but compact well, shed water, and offer long-term durability for driveways in Texas soils. For best results, use fill dirt only to raise or regrade, then finish with 3–6 inches of road base or crusher-run and a top layer of crushed limestone.

Hello Gravel's minimum order is 3 tons, and standard delivery is usually scheduled 2+ business days out, with next-day available before noon CST for an added fee. Typical dump trucks are tri-axle and require clear overhead access (12–16 ft), a level drop zone, and enough room to back or turn (about 30–40 ft turning space); tight gates, steep drives, or long distances from the street can add fees. Request tailgate spreading at checkout, but note drivers perform it at their discretion and safety permitting.

Install fill dirt in 6–8 inch lifts, moisture-condition each lift as needed, and compact to the specified density with a plate compactor or roller; proof-roll soft areas before placing fill. Consider geotextile fabric over very soft subgrades and finish with a structural surface (road base or crushed limestone) to minimize dust and ongoing settlement. For critical fills or driveways, hire a local contractor experienced with West Texas clay and limestone to ensure proper compaction and drainage.