Fill Dirt in Greatwood, TX

Delivered fill-dirt prices in Greatwood usually vary by quantity, moisture content, and haul distance. Expect a ballpark of about $10 to $35 per ton (roughly $12 to $45 per cubic yard), with smaller orders and long hauls toward the high end. For an exact quote, check availability by zip code on Hello Gravel or contact our team for current local pricing.

For driveways and pads in Greatwood's clay soils, choose non-organic, well-graded select or structural fill rather than topsoil or loose fill. This type of fill has minimal organic matter and compacts well, reducing future settlement and shrink-swell issues. Finish with a proper base or surfacing layer (road base or crushed stone) for a durable driving surface.

One cubic yard equals 27 cubic feet. Fill-dirt in Greatwood typically weighs about 1.2 to 1.6 tons per cubic yard depending on moisture and compaction; a common rule of thumb is 1.3 tons per cubic yard. So to convert, multiply cubic yards by ~1.3 to estimate tons, and divide tons by ~1.3 to estimate cubic yards.

Hot, dry periods cause clay to shrink and crack while heavy rain or flooding can saturate fill and cause settlement or loss of compaction. Both cycles reduce long-term stability unless the fill is placed correctly with controlled moisture, compacted in lifts, and protected by good drainage. Plan for drainage away from foundations and consider a granular cap to limit moisture intrusion.

Hello Gravel's minimum order is 3 tons, and most suppliers serving Greatwood deliver via tri-axle dump trucks, which commonly haul about 10 to 16 cubic yards (roughly 12 to 15 tons for fill-dirt). Smaller local dump trucks are sometimes available but can increase per-ton cost. Note that placement constraints (driveway width, overhead wires, or septic fields) can affect where trucks can dump and whether tailgate spreading is possible.

Possibly. Greatwood lots are subject to local HOA rules and Fort Bend County or the city that governs your property may require grading, drainage, or erosion-control permits for significant fills. Before ordering large volumes, check with your HOA and the county or city permitting office to confirm any approvals, setbacks, or paperwork required.

Use fill-dirt to raise grade or backfill, but not as a final driveway surface. For driveways and better drainage in Greatwood's clay soils, build a compacted fill subgrade, then add several inches of road base or crushed limestone as the structural, load-bearing layer, and top with 1 to 3 inches of crushed stone if desired for appearance. That layered approach gives strength, drainage, and reduced maintenance versus leaving fill-dirt exposed.

If left as a naked fill-dirt surface, expect frequent patching and regrading—often annually after heavy rains. With a properly compacted subgrade and a road base or crushed stone wearing layer, you can expect many years of service; reasonable maintenance (occasional regrading and topping) every few years is typical, and a well-built drive can last 10+ years. Maintenance frequency depends on drainage, traffic, and whether the surface is stabilized.

Place fill in uniform lifts (commonly 6 to 8 inches loose thickness), control moisture to near optimal compaction moisture, and compact each lift with the appropriate equipment (plate tampers for small areas, rollers for larger areas). For sites with highly expansive clays, consider undercutting and replacing with engineered structural fill, adding geotextile or geogrid, and getting a geotechnical recommendation for critical foundations or pavements. Always verify compaction with field testing when building structural elements.

Use Hello Gravel to check your zip code and get connected with local suppliers and haulers who serve Greatwood; you can request DOT specs, gradation data, or material tickets from suppliers when you get quotes. Pricing will vary by supplier, material source, and haul distance, so request written specs and compare delivery fees before ordering. If you need materials for engineered work, ask the supplier for certification and any lab results that show compliance with the required spec.