Fill Dirt in Burkburnett, TX

Fill dirt is unprocessed subsoil used to raise and level ground; it usually contains clay, sand, and small rock but little organic matter. In Burkburnett you use it when you need to build up grade, backfill behind foundations or low retaining walls, or raise a yard before adding topsoil or gravel. It is not intended as a finished surface for driveways or landscaping without a proper wearing layer on top.

Prices vary by supplier, haul distance, and quantity, but material alone in West Texas often ranges from about $6 to $20 per ton. Delivered cost to Burkburnett properties typically falls between about $20 and $50 per ton depending on truck access, order size, and any spreading requested. For an exact price, enter your zip code on our site or contact our team to get local quotes.

For driveways use well-graded, compactable fill dirt with some clay content that will hold compaction, then cap it with a proper gravel base and wearing surface. For foundation work, use select or engineered structural fill specified by an engineer rather than generic fill dirt; many structural projects in Burkburnett require tested, low-organic material and staged compaction. Always confirm requirements with your engineer or building inspector before ordering.

Hot, dry summers in Burkburnett cause clay-rich fill dirt to shrink and crack as it loses moisture, which can lead to settling if not compacted properly. Occasional heavy storms can cause erosion or washouts on newly placed fills unless you grade for drainage and install erosion controls. To reduce problems, compact fill in lifts, install proper slope and swales, and delay final grading until moisture conditions are stable.

As a rough guide, 1 cubic yard of fill dirt weighs about 1.3 tons. Examples: to raise a 12 ft by 100 ft driveway 4 inches you need about 6.7 cubic yards (roughly 9 tons); a typical small yard regrade (20 ft by 30 ft raised 6 inches) needs about 3.7 cubic yards (roughly 5 tons); backfilling a low retaining wall often uses 0.5 to 1.5 cubic yards per linear foot depending on wall height. These are estimates—use our calculator or contact us with project dimensions for a precise quantity.

Hello Gravel's platform lists a 3-ton minimum order, which covers small projects and matches many haulers' policies. Some local suppliers or long-haul deliveries may set higher minimums (5 to 10 tons) or charge additional trip fees for tight access in Burkburnett. Deliveries are made by contracted dump trucks (usually tri-axle), so note driveway width, overhead obstructions, and preferred drop location when ordering.

Large fills, regrading that affects drainage, or work in floodplain areas can require permits or inspections from the City of Burkburnett or Wichita County, and you may need erosion control measures. If your project affects neighboring properties or public drainage, check local planning and building departments before placing orders. For structural fills near foundations, involve a licensed engineer and follow any required permit conditions.

Fill dirt is usually the least expensive option and is intended for bulk raising and backfill, not as a finished surface. Crusher run and decomposed granite cost more but provide structural base and better surface performance for driveways and pathways, while topsoil costs more and contains organic material for lawns and planting. Choose fill dirt for bulk grade work, then cap with crusher run or topsoil depending on your final surface needs.

Place fill dirt in lifts of 4 to 6 inches and mechanically compact each lift with a plate compactor or roller to achieve even, staged density. If fill is very dry, lightly moisten before compaction—do not oversaturate—and avoid placing large fills during extreme heat when moisture loss is rapid. Also compact near structures per engineer specifications and provide finished grading and erosion control to reduce future settling and washouts.

As a base material that is properly compacted and capped with a gravel driving surface, fill dirt can serve for many years, but some settling is normal and may require periodic topping up and regrading. For uncovered or poorly compacted fills expect more frequent maintenance after heavy rains or seasonal drying. Budget for occasional maintenance like adding a few tons of material every few years for driveways and check drainage after storms.

Sand drains better than clay-rich fill dirt, so sand-based fills are preferred where drainage is critical. Clay-heavy fill dirt can retain water and lead to poor drainage or expansion problems, so engineers often specify a compacted granular or engineered fill with adequate drainage layers for foundation work in Burkburnett. Always follow site-specific recommendations from a geotechnical engineer for structures and foundations.