Fill-dirt in Springfield, TN

In Springfield and surrounding West Tennessee towns, delivered fill-dirt typically ranges from about $8 to $20 per ton (roughly $6 to $15 per cubic yard), depending on moisture, truck distance, and local supplier rates. Hello Gravel lists a 3-ton minimum; full truckloads (tri-axle) from local quarries usually lower the per-ton price. Exact pricing is shown at checkout after you enter your zip code and delivery date.

Common sources are local quarries, landscape supply yards, and hauling contractors in Robertson County; Hello Gravel connects you with trusted local suppliers and dump-truck haulers in the Springfield area. For specific names and availability, enter your zip code on Hello Gravel or call our team so we can match you with nearby vendors and show delivery options.

For driveways and structural fills in West Tennessee clay, place fill-dirt in lifts no thicker than 4 to 6 inches and compact each lift thoroughly with a plate compactor or roller. Aim for multiple compacted lifts until you reach the finished grade; consider a compacted aggregate base (crusher run or limestone) on top of the fill for driveway surfaces to improve drainage and longevity.

Use 1 cubic yard = 27 cubic feet and an approximate weight of 1.2 tons per cubic yard for typical fill-dirt. Per square foot: 2u0022 = 0.00617 cubic yards (about 0.0074 tons), 4u0022 = 0.01235 cubic yards (about 0.0148 tons), 6u0022 = 0.01852 cubic yards (about 0.0222 tons). For an easier rule of thumb: per 1,000 sq ft you need ~6.2 cy (7.4 tons) at 2u0022, ~12.3 cy (14.8 tons) at 4u0022, and ~18.5 cy (22.2 tons) at 6u0022.

Fill-dirt is good for raising grades and filling voids but typically contains more fines and clay than crusher run, so it can hold water and settle more in West Tennessee's clay-prone, heavy-rain seasons. For driveways or areas needing drainage and load-bearing capacity, a compacted layer of crusher run or crushed limestone as a cap performs better. Use fill-dirt for bulk fill, then cap with a granular base where traffic or drainage is a concern.

Yes — for large fills or grading changes in Springfield/Robertson County you may need to check local zoning, stormwater, and erosion control rules; permits can apply if you alter drainage, exceed certain volumes, or affect setbacks. Contact Robertson County planning or the City of Springfield permitting office before major projects, and have site plans ready if required.

Hello Gravel can request tailgate spreading, but drivers perform it only at their discretion for safety and access reasons and it's not guaranteed. Local contractors offer spreading and compaction; small equipment daily rates in the Springfield area commonly run from about $300 to $900 for a machine plus operator, with manual labor billed separately—get written quotes that include mobilization and disposal of excess material.

For flood-prone or poorly draining lots near Springfield, use clean, low-organic fill with moderate sand and granular content (for improved drainage) and minimal high-plastic clay or organic matter. Pair fill with geotextile fabric, sub-surface drains, and a graded outlet; always compact in lifts and consider engineering advice for sites near creeks or FEMA flood zones.

Full truckloads (tri-axle, roughly 10 to 14 tons) usually reduce the per-ton price because of lower hauling cost per ton and fewer delivery trips. Smaller orders (3 to 6 tons) meet Hello Gravel's minimum but often carry a higher per-ton price and sometimes a delivery fee—compare the delivered per-ton rate in checkout to see the savings for larger loads.

Common search terms include 'fill dirt delivery Springfield', 'tons of fill dirt', 'fill dirt price per yard', 'compaction for fill dirt', 'best fill for drainage', and 'deliver fill dirt near me'. Homeowners are usually concerned about delivery placement, settlement, drainage implications, compaction, and local permit requirements.