Fill-dirt in Michie, TN

Fill-dirt is a coarse, low-organic soil used to raise grades and fill voids; it usually contains a mix of sand, silt, gravel, and subsoil rather than topsoil. In Michie and West Tennessee it often reflects local clay and sand content, so color and texture can vary by supplier; expect a heavier, compactable soil rather than loose topsoil with roots.

Typical delivered pricing in the Michie area is commonly in the range of $15 to $35 per ton, but rates vary by supplier, distance, and season. Hello Gravel has a 3-ton minimum order; delivery fees depend on your exact zip code and truck access, so request a zip-code quote for an exact price.

Use cubic yards = area (sq ft) x depth (ft) / 27, then multiply by about 1.3 tons per cubic yard (typical delivered fill-dirt density). For a 20x40 (800 sq ft) area: 1 inch ≈ 3.2 tons; 3 inches ≈ 9.6 tons; 6 inches ≈ 19.3 tons; 12 inches ≈ 38.5 tons. These are estimates only—actual tons vary with moisture, compaction, and material; order a bit extra to allow for settlement and compaction.

For a driveway or garage pad use clean, non-organic fill-dirt free of roots and debris, compacted in 4-6 inch lifts with a plate compactor or vibratory roller until firm. Aim for a well-compacted base; many contractors target about 90% to 95% relative compaction (standard Proctor), but for pavement or slab bases it’s better to place a granular stone layer (4-6 inches of crushed stone) on top of compacted fill-dirt for drainage and stability. If you plan to pour concrete, replace the top 4-6 inches under the slab with compacted crushed stone rather than relying on fill-dirt alone.

Michie’s wet summers and periodic freeze-thaw cycles mean poorly drained fill-dirt can soften, settle, or heave if moisture is trapped. Grade surfaces for positive drainage away from structures, use a granular layer over compacted fill where needed, and consider geotextile fabric or drainage pipes in low spots to reduce saturation and long-term settlement. Choosing fill with a balanced sand/silt mix and avoiding high-organic material will improve performance in local conditions.

Permitting rules vary by project type: simple driveway resurfacing or small grade changes often do not require a county building permit, but constructing a new garage pad, altering driveway access to a state road, or septic system work commonly requires permits and inspections. Contact the McNairy County Building/Planning office or the Town of Michie clerk before starting work to confirm requirements, and check with Hello Gravel if you need documentation for your supplier.

Hello Gravel sources regional suppliers that typically deliver to Michie using tri-axle dump trucks; common delivery radii are 20 to 60 miles depending on local pits and seasonal availability. Trucks usually offload by rear dump; optional tailgate spreading may be requested at checkout but is at the driver’s discretion. For installer services (skid steers, compactors, rollers) contact local contractors or request referrals through Hello Gravel when you get a quote.

Measure your area, calculate volumes using our material calculator, and add 5% to 15% for compaction and settlement when ordering. Request delivery details at checkout (preferred drop location, gate codes, driveway access) and note any spreading requests—remember drivers may or may not be able to spread material safely. If your site has poor drainage or organics, discuss options with Hello Gravel or a local contractor before delivery to avoid rework.