Fill-dirt in Gladeville, TN

In West Tennessee delivered fill-dirt commonly ranges from about $12 to $40 per ton, which typically equals roughly $16 to $55 per cubic yard depending on moisture and compaction. Local hauling, minimum-order size, and how many miles from a quarry you are from Gladeville drive the price; Hello Gravel shows exact pricing after you enter your zip code and desired quantity. Expect higher per-unit prices on very small orders and lower rates for larger truckloads.

Suppliers that serve Gladeville are usually regional quarries, landscaping yards and dirt haulers based in Rutherford and nearby counties (including Murfreesboro and parts of the Nashville area). Typical minimum orders for truck-delivered fill-dirt are 3 tons with some suppliers preferring 5-10 tons for residential deliveries; delivery fees vary by distance and lot access and may be waived in many areas through Hello Gravel. For exact supplier options and minimums near your Gladeville address, use Hello Gravel to check availability and get firm quotes.

Calculate volume then convert to tons: 1,000 sq ft raised 3u0022 (0.25 ft) is about 9.26 cubic yards; 6u0022 is about 18.52 cubic yards; 12u0022 is about 37.04 cubic yards. Fill-dirt density typically ranges from about 1.2 to 1.6 tons per cubic yard, so expect roughly 11 to 15 tons for 3u0022, 22 to 30 tons for 6u0022, and 44 to 59 tons for 12u0022. Always order an extra 5-10% to account for settlement, compaction, and spreading losses in West Tennessee clay conditions.

West Tennessee soils often contain clay that holds water and can expand or shrink; plain uncompacted clay-heavy fill can lead to poor drainage and uneven settling. For driveways, pads, or grading in Gladeville, choose fill-dirt that is well-graded with some coarse material or mix in gravel/stone for better drainage, and plan for proper site grading and a drainage path away from structures. If you suspect high clay content or poor drainage, consider a geotechnical check or using engineered fill in critical areas.

Small residential fills are typically compacted in lifts (4-8 inches) using a plate compactor or jumping jack for narrow spots; larger areas use a small vibratory roller or tandem roller for better results. Contractors in the region aim for 90% or higher of maximum dry density; equipment rental runs about $60-$200 per day for plate compactors and $200-$500 per day for small rollers, while operator labor commonly adds $50-$100 per hour depending on scope. Ask contractors for a written compaction plan and proof of experience for driveways or building pads in Gladeville.

By itself, fill-dirt is not highly erosion-resistant in heavy rain or on slopes because fine particles wash away; freeze-thaw cycles in West Tennessee can amplify settling and surface erosion if the material is not compacted. Improve longevity by compacting in lifts, installing temporary erosion controls (silt fence, straw), adding a top layer of gravel for traffic areas, and using drainage measures like swales or French drains. Stabilizers (lime or cement) or mixing in coarser material can improve strength but should be used based on site needs and local contractor advice.

Fill-dirt is best for raising grade, filling low spots, and general earthwork where a soil finish is acceptable; it is not ideal as a finish surface for driveways or where strong load-bearing capacity is required. Crushed stone or crusher run provide better drainage and load distribution for driveways and building pads, while clean stone or specially graded backfill is preferred for septic systems and utility trenches. For many Gladeville projects the typical approach is fill-dirt for bulk grade work followed by a compacted stone layer where drainage and strength matter.

Small residential deliveries for yard grading usually do not require permits, but larger fills, commercial projects, or work that alters stormwater flow often fall under Rutherford County or local permit rules. Check with Rutherford County Planning and Zoning and your HOA (if applicable) before large fills or projects that change drainage or create retaining walls. If you are unsure, Hello Gravel's team can advise on common local requirements but you should confirm with county officials for legal requirements.

Labor and machine rates vary, but you can expect contractor labor for spreading and compacting to run roughly $50 to $150 per hour for a small crew and equipment package in the Gladeville area. Some contractors price by the job or by the ton for spreading and grading, with per-ton spreading rates often falling in the $2 to $8 per ton range depending on accessibility and how much machine work is needed. Always get at least two local quotes and ask whether hauling, spreading, and compaction are bundled or priced separately.

Yes. Through Hello Gravel's network many suppliers offer small-load deliveries (minimums often start at 3 tons) and same-week or next-day delivery options when schedules allow, with exact availability depending on your zip code near Gladeville. Equipment rental for spreading and compacting (plate compactors, small rollers) is commonly available locally; Hello Gravel can include notes on your order for delivery access and help coordinate equipment or contractor referrals when available.